2
13
Lay Repose® Care-Sit cover out with xing straps beneath.
Place the Repose® Care-Sit inatable inner section lengthways,
insert into Repose® Care-Sit cover and lay at with valves face
down. (See g. 4) Zip the cover closed.
Ensure that the Repose® Care-Sit is positioned correctly before
securing. (See g. 5)
6
8
4
•
•
•
IMPORTANT NOTICE
REPOSE®CARESIT CAN BE CLEANED AND REUSED. REPLACE IF
PRODUCT IS DAMAGED OR THREADBARE.
CHECK PRODUCT REGULARLY TO ENSURE CORRECT INFLATION LEVEL.
IN CASE OF DOUBT, REPEAT PUMPING PROCEDURE WITH THE USER
OFF THE PRODUCT.
KEEP AWAY FROM SOURCES OF DIRECT HEAT INCLUDING
CIGARETTES, AND SHARP OBJECTS ESPECIALLY PETS’ CLAWS THAT
MAY CAUSE A PUNCTURE.
POSITION ON THE WHEELCHAIRS / STATIC CHAIRS SHOULD BE
CHECKED REGULARLY TO ENSURE THE CORRECT AND SAFE USE.
FOR FURTHER INSTRUCTIONS AND INFORMATION, SEE PUMP.
IF DETERIORATION IN SKIN CONDITION IS NOTED, CLINICAL ADVICE
SHOULD BE SOUGHT AND IF SO ADVISED, DISCONTINUE USE OF
PRODUCT.
WHEN DEFLATED KEEP AWAY FROM BABIES AND SMALL CHILDREN.
PRECAUTIONS
ONLY USE REPOSE®CARESIT OVERLAY WITH REPOSE® CARESIT
COVER.
REPOSE®CARESIT CAN BE CLEANED AND REUSED.
CHECK PRODUCT REGULARLY TO ENSURE CORRECT INFLATION LEVEL.
IN CASE OF DOUBT, REPEAT PUMPING PROCEDURE WITH THE USER
OFF THE PRODUCT.
KEEP AWAY FROM SOURCES OF DIRECT HEAT INCLUDING
CIGARETTES, AND SHARP OBJECTS ESPECIALLY PETS’ CLAWS THAT
MAY CAUSE A PUNCTURE.
MAXIMUM USER WEIGHT 139KG.
POSITION ON THE CHAIR SHOULD BE CHECKED REGULARLY TO
ENSURE THE CORRECT AND SAFE USE.
REPOSE®CARESIT COVER IS ONLY TO BE USED WITH REPOSE®
CARESIT INFLATABLE INNER SECTION.
FOR FURTHER INSTRUCTIONS AND INFORMATION, SEE PUMP.
REPLACE IF PRODUCT IS DAMAGED OR THREADBARE.
Remove the Repose® Care-Sit inatable inner section from the
tube, ret the two tubes together to form a pump.
Connect the valve on the pump to the valves on the device - Push
to t (See g. 1).
Inate each Repose® Care-Sit inatable inner section until you
hear air exhausting from the pump valve. Discontinue pumping
and wait until you no longer hear air escaping (See g. 2).
Disconnect from pump. Cover the valves on the device using the
solid end of the valve cap (See g. 3).
Turn over with valves underside and away from user.
•
•
•
•
•
FOR MORE INFORMATION PLEASE SEE THE REPOSE®CARESIT™
INFLATABLE INNER SECTION INSTRUCTIONS, INCLUDED WITHIN THE
PUMP.
Insert the open end of the valve cap into both valves. Air can now
escape (See g. 10).
Fold and roll up the device starting at the point furthest away
from the valve until all air is expelled. (See g. 11).
Re-fold, and re-roll as tightly as possible (See g. 12).
Replace device into the pump. Ret the two tubes together and
rotate outer tube until it clicks closed.
•
•
•
•
REPOSE®CARESIT COVER IS ONLY TO BE USED WITH REPOSE®CARE
SIT INFLATABLE INNER SECTION.
ONLY TO BE USED WITH WHEELCHAIRS / STATIC CHAIRS NOT TO BE
USED AS A SLING OR A FLOTATION DEVICE.
MAXIMUM USER WEIGHT 139KG
LIMITATIONS FOR USE
Inate Inatable Inner Section
Insert Inatable Inner Section
into Care-Sit Cover
Secure Repose®Care-Sit to Wheelchair
1
2
3
10 12
Loop both of the upper xing straps over the wheelchair handles.
(See g. 6)
Loop lower xing straps around the back of the wheelchair under
the arm rests. (See g. 7)
Clip the xing strap into place and adjust until secure. (See g. 8)
•
•
•
5