Resolution Products Repeater Translator RE220T User manual

RE220T_2GIG_Repeater_Translator.doc
Page 1 of 4 11/29/2010 4:43:00 PM
.ResolutionProducts.com
Wireless
Security
Solutions
RE220T Repeater Translator™, 2GIG
®
-Compatible
Features
•Listens to distant 2GIG and Honey ell® -protocol ireless devices, and
re-transmits them to control panel.
o2GIG Signals  2GIG Signals
oHoney ell Signals  Honey ell Signals
•Extends range of system.
•No sensor enrollment required.
•Received IDs are passed on unchanged to panel. All sensor alarm,
supervisory and trouble signals are passed through.
•Main device has its o n unique 2GIG ID for supervisories, complete
reporting of main device tamper, external po er supply fault and lo
battery.
•Dual antennas for both Receive and Transmit diversity for increased
range.
•Back-up battery protects during loss of external po er.
ey Instructions
•External supply: 12V DC, recommend 30+ mA.
•3 AAA Alkaline batteries give 72 hours backup if external supply fails.
INSTALL BATTERIES ONLY WHEN EXTERNAL SUPPLY IS READY TO CONNECT.
•Enrolling:
Distant sensors may be enrolled into 2GIG system as normal. They
are not enrolled in the Translator.
If trouble supervision of the Translator itself is desired, assign the
Translator to a zone for sending check-in supervisories, cover tamper
and lo battery messages.
•24 Hour Aux Zone Type – When cover opened: “fault” hen
system not armed, “alarm” hen system armed.
• Supervised RF input type
•When prompted, toggle the tamper s itch to enroll the serial
number.
Main device does not need to be enrolled in the panel for the
repeating function to ork.
•Never put more than one Repeater in a 2GIG installation.
RE220T_2GIG_Repeater_Translator.doc
Page 2 of 4 11/29/2010 4:43:00 PM
.ResolutionProducts.com
Operation
•Translator hears distant 2GIG protocol sensors and repeats the 2GIG
information to the panel. Translator hears Honey ell sensors and
repeats the Honey ell information to control panel. Remember, 2GIG
panels can hear Honey ell sensors.
•Generally, sensors send 8 identical “packets” of information. No matter
ho many packets the Translator hears, it ensures that a complete set
of 8 packets are repeated to the control panel.
•Translator Main Zone ireless transmission ( unique 2GIG ID):
Tamper, hen cover opened. Also sends restore.
Lo battery, hen lo battery. Also sends restore.
Supervisory every hour. Supervisory stopped if 12V DC po er absent.
•LED Operation
Green LED
•On if AC po er present.
•Blinks on receipt of 2GIG & Honey ell-compatible packets.
Red LED
•On if device lo battery (unless there’s no AC po er).
•Blinks on transmit of 2GIG & Honey ell-compatible packets.
•Application Diagram
Because the Translator has t o antennas, for both receive and
transmit diversity, it ill generally have better range than all
sensors, and many panels (particularly those ith internal antennas).
Because of this, it tends to more than double the distance the
remote sensor can be from the panel.
Place the Repeater generally half- ay bet een distant sensor and
panel.
Translator may also hear and repeat sensors that are close to panel…
panel ill simply hear the close sensor signals again. It is extremely
rare that this ill cause any problem.
2GIG
Wireless
Panel
Honey ell
s
ignal
translates to
Honey ell signal
2GIG signal translates to 2GIG signal

RE220T_2GIG_Repeater_Translator.doc
Page 3 of 4 11/29/2010 4:43:00 PM
.ResolutionProducts.com
Specifications
Backup batteries: Three AAA Alkaline.
External supply: 12V DC, at least 50mA.
Current dra ith supply: 4mA, normal operation.
Po er Fail Conditions: 12V DC gone. Translator device ID
supervisories (including lo battery reports)
are stopped during 12V DC loss.
Back-up Battery Life on 12V DC Fail: 72 hours (cumulative).
Device Lo Battery: When approximately 48 hours remain in back-up.
Housing dimensions: 4x6x1 inches
Specifications subject to change ithout notice.
Internal Picture
Po er Terminals
Tamper
S itch
& spring
Unused:
Device Type Indicator LEDs
and Enrollment button
Battery bucket for 3 AAA alkalines
Indicator LEDs & buzzer
2 Antennas for:
Dual Diversity Receive and
Dual Diversity Transmit
Note: Antennas mounted
on outer terminals
RE220T_2GIG_Repeater_Translator.doc
Page 4 of 4 11/29/2010 4:43:00 PM
.ResolutionProducts.com
Notices
“GE”, “Honey ell”, “2GIG” and “DSC” are trademarks o ned by General Electric Company,
Honey ell International Inc., 2GIG Technologies, Inc., and Tyco Safety Products Canada LTD,
respectively.
Resolution Products, Inc. products ill function ith one of either GE, DSC, 2GIG or Honey ell
systems. Ho ever, no Resolution product is produced by, endorsed by, nor is officially
associated ith GE, Honey ell, 2GIG or DSC. Resolution recommends verifying proper
enrollment and operation, per control panel installation instructions, at installation.
Do not use Translator for life safety devices, such as smoke or CO sensors.
Warranty
Resolution Products, Inc. ill replace products that are defective in their first year.
FCC Notice
This device complies ith Part 15 of the FCC rules. Operation is subject to the
follo ing t o conditions:
This device may not cause harmful interference.
This device must accept any interference that may be received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could
void the user's authority to operate this equipment.
FCC ID: U5X-RE224
IC Notice
This product meets the applicable Industry Canada technical specifications/Le présent
materiel est conforme aux specifications techniques applicables d’Industrie Canada.
Operation is subject to the follo ing t o conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated po er (e.i.r.p.) is not
more than that permitted for successful communication.
This device has been designed to operate ith the antennas listed belo , and having a
maximum gain of 2 dBi. Antennas not included in this list or having a gain greater than
2 dBi are strictly prohibited for use ith this device. The required antenna impedance
is 50 ohms.
- Resolution-supplied 8.5" monopole antenna
IC: 8310A-RE224