Dear Customer,
Congratulations on your purchase.
At
Retro Manufacturing, we are obsessed with musical
reproduction at its best, and are pleased you chose our product.Through years
of
engineering expertise, and critical testing procedures, we have created awide range
of
products that reproduce music with all the clarity and richness you deserve.
Please read your warranty and retain your receipt and original carton for possible future
use.
Great product and competent installations are only apiece
of
the puzzle when it comes to
your system.
If, after reading your manual, you still have questions regarding this product, we
Be sure to have your model number and date
of
purchase available when you call.
INSTALLATION CONSIDERATIONS
The following
isa
list
of
tools needed for installation:
#2 Phillips screwdriver IBattery post wrench IHand held drill wlassorted bitsl Wire stripperslWire crimpers
Wire cutters
Since some
of
these RetroMod™ Full Range Speakers are most often used as direct replacements
for stock speakers and are shipped without grilles.
For custom installations see aprofessional installer for help with your install.
CAUTION
If
you feel unsure about installing this system yourself, have it installed by a
qualified professional installer.
CAUTION Before installation, disconnect the battery negative (-) terminal to prevent
damage to the unit, fire and/or possible injury.
Before beginning any installation, follow these simple rules:
1.
Be sure to carefUlly read and understand the instructions before attempting to install the unit.
2. For safety, disconnect the negative lead from the battery prior to beginning the installation.
3.
For easier assembly,
we
suggest you run all wires prior to mounting your unit in place.
4. Use high quality connectors for areliable installation and to minimize signal
or
power loss.
5.
Think before you drill! Be careful not to cut
or
drill into gas tanks, fuel lines, brake
or
hydraulic lines,
vacuum lines
or
electrical wiring when working on any vehicle.
6.
Never run wires underneath the vehicle. Running the wires inside the vehicle provides the best
protection.
7.
Avoid running wires over
or
through sharp edges. Use rubber or plastic grommets to protect any
wires routed through metal, especially the firewall.
MOUNTING
1. Determine where the speakers will be mounted. Ensure an area large enough for the speaker to
mount evenly.
Be
sure that the mounting location is deep enough for the speakerto
fit;
if
mounting in
adoor, operate all functions (windows, locks, etc.) through their entire operating range to ensure
there is no obstruction.
2. Refer to the specification chart to determine the proper diameter hole to cut for your speaker
model.
3.
Using the grille (not included in most models) as atemplate, mark the locations for the mounting screws.
Drill the holes with a1/8" bit.
4. Feed the speaker wires through the cutout and connect to the speaker terminals. Be sure to observe
proper polarity when connecting the wires.The speaker's positive terminal is indicated with a"+".
5.
Fit the speaker to the cutout. Fit the grille over the speaker (Where applicable). Mountthem using the
enclosed screws.
6. Tighten the screws until the speaker and is snug
in
place to prevent rattling. Do not
overtighten the screws.
-2-
