RevAir Reverse-Air Dryer User manual

QUICK START GUIDE
REV 3.0

Wash hair. Towel dry. Detangle.
RevAir works best on clean, towel-
dried hair in conjunction with any
RevAir hair primer.
Do not use oils or sticky xatives
prior to Reving.
Do not saturate hair with product
or water to the point of dripping on
or in the device.
Power-on the Base Unit and
Wand. Be sure your preferred
settings are set. See page 4.
Insert hair into the Wand, up to
your scalp. Keep it at or near your
scalp. No need to move up and
down the hair section.
When dry, remove and repeat,
section by section, until complete.
Enjoy your freshly Rev'd hair.
WASH REV LOVE!
YOU DRY, STRETCH & STRAIGHTEN YOUR HAIR
changing the way
2 // for tips, tricks, and answers to FAQs visit myrevair.com

looking for a specic solution? visit support.myrevair.com // 3

4 // for tips, tricks, and answers to FAQs visit myrevair.com
SETTINGS
SLOW + LOW
Begin by setting your Reverse-
Air Speed Dial to Level 2 or
lower. Increase the speed level
until you nd your ideal tension.
SECONDS
FAST TRACK
Drying times vary by hair type but
commonly range from 30 to 90
seconds per section.
PASS THE TEST
To assure a section is dry, pull the
Wand a few inches from the scalp
to feel for dampness.
If you still have a bit of dampness
or texture, repeat until hair feels
dry, noting the time it took to get
it just right.
II =High Temp
O=No Heat | Cool Shot
I=Low Temp
Note // Should you experience
even a tiny tangle, the Speed
Dial should be reduced.
THE HEAT IS ON
Set the Temperature Control on
the Wand at Low ( I ). If you nd
you need more heat, switch to the
High ( II ) setting.
SETTING UP FOR SUCCESS
To achieve the best results, pay attention to these important guidelines.
CAUTION // While RevAir uses
nearly half the heat of blow
dryers, do not use the High
( II ) temperature setting unless
using a speed setting of Level 2
or higher.
Note // The section times
shown to the right are averages.
Individual hair characteristics
such as volume, porosity, strand
thickness, density, and overall
health can affect your personal
drying time.

looking for a specic solution? visit support.myrevair.com // 5
SECTIONS
SIZE MATTERS
Begin with a 3-inch by 3-inch
section at the scalp. If your hair
has a lot of volume, start slightly
smaller, as not to inhibit airow in
the Wand.
ROOT AROUND
When held to the scalp, the
Wand should reach all roots by
gently moving the Wand Mouth
across the section. No need to
move the wand up and down the
hair strands, keep it close to the
roots.
GO WITH THE FLOW
Should a section of hair be
too large in volume, the Heat
Chamber will shut down
indicating the section size should
be reduced. Simply remove the
hair section and retry with less
hair. The Heat Chamber will
resume automatically.
SETTING UP FOR SUCCESS
To achieve the best results, pay attention to these important guidelines.
COILY // ZIG-ZAG
Average Section Time: 90 sec
CURLY
Average Section Time: 60 sec
WAVY
Average Section Time: 45 sec
STRAIGHT
Average Section Time: 30 sec
Note // The Wand includes an
internal sensor to monitor heat
levels minimizing heat exposure.

6 // for tips, tricks, and answers to FAQs visit myrevair.com
Empty any accumulated hair or debris from the Filter Basket. Rinse the
Filter Basket under warm water. Scrub with a soft brush (toothbrush)
and mild dish washing liquid.
Alternatively, with the open side up, run the Filter Basket through the
wash cycle in the top rack of your dishwasher.
Removing hair and dust from your Filter Basket is NOT
enough. Empty and clean the filter every 5 uses.
Your RevAir is equipped to function as an all-in-one storage device.
With Wand Docking Hook facing you, wrap Hose (going clockwise)
twice around Base Unit.
Secure the Wand to the hook via the Wand Docking Groove.
ESSENTIAL MAINTENANCE
To keep your RevAir in tip-top shape, cleaning your Filter Basket is necessary.
Note // For complete details on how to clean your lter as well as
additional maintenance tips, please review your Operating Manual or our
online FAQ section at myrevair.com
STORING REVAIR
CLEANING SIGNALS
Washing your lter regularly will ensure your RevAir will provide the best results. If you begin to experience
any of the following, your Filter Basket is likely overdue for a cleaning:
Experiencing less
tension (suction)
on your usual
setting.
The Wand Mouth
feels hotter than
normal.
Results are less
sleek and silky
in texture and
appearance.
The Wand heat
begins to shut off
during use.
CLEANING THE FILTER BASKET
4.3.2.1.

looking for a specic solution? visit support.myrevair.com // 7
HEAT PRODUCING WAND
1 | Temperature
Control
2 | Wand Mouth
3 | Heat Chamber
4 | Wand/Hose
Connector
5 | Strain Relief
7 | Main Power
On/Off Switch
8 | Wand Docking
Hook
9 | Air Outlet
10 | Exhaust Filter
11 | Cord Wrap
Plate
12 | Reverse-Air
Speed Dial
13 | Filter Panel
Latch
14 | Filter Panel
BASE UNIT
Make sure the Air Outlet is unobstructed, giving at
least two feet clearance, when the device is on.
FILTER BASKET
6 | Filter Basket
Tab
WHAT'S WHAT
A look at the ner details.

REV IT. SHARE IT. #MYREVAIR
Customer Care and Support:
support.myrevair.com
[phone]
20200821 | RA8005 | REV 3.0
BLOW YOUR MIND NOT YOUR HAIR