RF SOLUTIONS HORNETPRO User manual

HORNETPRO Remote Control System
Extend your system
Depending on your application or user requirement there are a number of additions you
can make to extend your remote control system.
Additional transmitters:
Our range of FOBBER key fob transmitters are available in various button options, from
a single button to 8 buttons.
Customise Your Key Fob
It is easy to make the system your own by having a custom sticker on the key fob.
From as little as £2.00 extra per key fob (MOQ and design complexity dependent) you
can have a custom key fob.
HORNETPRO Remote Control
QS-HORNETPRO-1
1 x Receive with Additional
Cable Feed
HORNETPRO
Remote Control
System Quick
Start Guide
Full details of HORNETPRO’s Data
is at www.rfsolutions.co.uk
Sales: [phone] Tech. Support: [phone]
Quick Start Guide
What’s in the box?
or
2 x Transmitters
(system only)
or
or

HORNETPRO Remote Control System
NOTE: Installation should be carried out by a qualified technician
Getting Set Up:
 Unscrew the 2 screws at the base.
 Remove base panel.
 Unscrew the antenna at top of enclosure.
 Lightly pull the PCB inside to remove.
Relay
Relay
Relay
0V
LOAD
12V
12V
0V
COM
NO
NC
Supply
Terminals
TRAP-RX
Below is a simple example showing one possible way to wire a relay in order to give
switched power to an external load:
When the relay is energised the ‘COM’ connects to ’NO’ and power is applied
to the Load.
NOTE: For full installation instructions and product specification, please see the
HORNETPRO Datasheet at www.rfsolutions.co.uk.
HORNETPRO Remote Control System
NOTE: Systems come pre-paired. Pairing instructions only need to
be followed for additional transmitters.
With this system, you can pair together any individual transmitter
switch, with a receiver relay output switch. Without opening either
enclosure...
1. Briefly (for less than 1 second) place a magnet next to the
top left of the receiver as shown, and then remove it.
2. The receiver will buzz once (One buzz means the receiver unit
is ready to allocate a transmitter to relay switch 1).
3. Press the switch on the transmitter which you wish to pair.
4. The receiver will buzz twice to confirm pairing.
5. Repeat for any additional transmitter switches.
NOTE: Each receiver has a maximum memory for up to 28 pairings,
these can be from any switches on any transmitters!
To select relay outputs 2,2,4, repeat step 3 above and count the
number of buzzes. 2 buzzes for relay 2, 3 for 3 etc.
Advanced operation - Pairing a transmitter button
Setting the Outputs Momentary or Latching Operation
1/2sec Mom = Relay will operate for 1/2sec
Mom = Relay will operate for as long as
transmitter switch operated
Latch = Relay will toggle ON/OFF on each
transmitter button press
Link Positions Switch relays
LK1 LK2 RLY 1 RLY 2 RLY 3 RLY 4
Open Open 1/2sec Mom 1/2sec Mom 1/2sec Mom 1/2sec Mom
Closed Open Mom Mom Latch Latch
Open Closed Mom Mom Mom Mom
Closed Closed Latch Latch Latch Latch
NOTE: If link setting is changed, power cycle the receiver (turn off/on) otherwise it will stay in
the same mode it was previously set in.