RH Baby&child RH TEEN SLOANE TRUNDLE BED TWIN User manual

1 of 2
1
2
3
4
5
6
7
HARDWARE & PARTS ENCLOSED
Lock Washer
Curved Washer
QTY
10 Pcs
10 Pcs
10 Pcs
1 Pc
16 Pcs
8 Pcs
SLOANE TRUNDLE BED TWIN - ASSEMBLY INSTRUCTIONS
PARTS INCLUDED
A. HEADBOARD (1)
B. SIDE RAIL (2)
C. FOOTBOARD (1)
D. SLATS (4)
E. PLATFORMS (2)
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the parts and hardware lists above to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
ASSEMBLY INSTRUCT I ONS
Wrench (3), Nut (4) and Spanner Wrench (5), as shown in Diagram I. Do not tighten.
2. Repeat the above procedure to attach the Footboard (C) to Side Rail (B), then tighten all the bolts.
3. Place the Slats (D) on the top of the Side Rail'‘''’s side slats and fasten using Screws (6), as shown in Diagram II.
4. Lay the Platform Panel (E) on the top of the Slats (D), then screw in the Screws (7), as shown in Diagram III.
Screw (4cm)
Screw (3cm)
Spanner Wrench
1. Stand the Headboard (A) upright and attach the Side Rail (B) by using Thread Rod (1), Curved Washer (2), Lock
5. Push the Trundle (F) into the bed frame, making sure the Trundle (F) front panel is flush with Side Rail (B),
F. TRUNDLE (1)
Thread Rod (0.8cm Diam*11.5cm)
Nut
10 Pcs
CARE INSTRUCTIONS
Spot clean only with a soft, damp cloth.
as shown in Diagram IV.
NO.
TOOLS NEEDED
Phillips Screwdriver (not included)

2 of 2
Diagram III
Diagram IV
Diagram II
A
B
C
D
E
F
Diagram I
B
6
7
2345
1
B
A