Page 2 of 2
ASSEMBLY & INSTALLATION
1. Carefully remove all parts from the box and remove all plastic
coverings.
2. Attach Mounting Plate (A) to wall’s outlet box and secure with
suitable mounting screws (not included) and proper fasteners
from your local hardware store.
3. Carefully inspect the sconce’s fixture wires. White wire is the
NEUTRAL WIRE. Black wire is the HOT WIRE. Bare wire is the
GROUND WIRE.
4. Carefully lift up the Backplate (C) with the light fixture and place it
close to outlet box for wiring.
5.
Connect the GROUND WIRE from the fixture with the ground wire
(usually bare) from your outlet box using a wire nut. If your house
does not have a ground wire, attach the GROUND WIRE from the
fixture to the green grounding screw inside of the outlet box.
IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
6. Connect the NEUTRAL WIRE from your fixture with the neutral
wire (usually white) from your outlet box using a wire nut.
7. Connect the HOT WIRE from your fixture with the hot wire
(usually black) from your outlet box using a wire nut. DO NOT
REVERSE THE HOT AND NEUTRAL CONNECTIONS OR
SAFETY WILL BE COMPROMISED.
8. Tuck the wire connection neatly into the wall’s outlet box.
9.
Attach Backplate (C) with light fixture to affixed Mounting Plate (A)
and secured with 3/16"L Hex Socket Set Screws (B) using Allen Key (G).
10.
Secure Crystal Panel (E) to the metal arm with Knurled Screws (D).
11. Insert the Lightbulbs (F) into socket.
12. Assembly is complete.
IMPORTANT PLEASE READ
SAFETY INSTRUCTIONS
(1) Must use an authorized and certified electrician for consultation
and installation. Electrician must be familiar with commercial-type
installation of very heavy sconce fixture and the hazards involved.
Electrician should install fixture as per applicable local installation code.
(2) FOR NONCOMBUSTIBLE SURFACE ONLY.
(3) This fixture has been rated for two (2) 30-watt maximum Type T9
standard lightbulbs (included). To avoid the risk of fire, do not exceed
the recommended wattage.
(4) The manufacturer and distributor accept no liability for incorrect
installation.
(5) Keep away from children.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow
it to cool prior to replacing the lightbulbs. Do not touch the bulb
when fixture is turned on or look directly at lit bulbs. Keep flammable
materials away from lit bulbs.
THIS PRODUCT IS NOT A TOY AND HAS NO PLAY VALUE.
CARE INSTRUCTIONS
Wipe all surfaces with a soft, dry cloth. Clean glass with a mild
soap and water mixture. Do not use any harsh cleaners (including
ammonia-based products) or abrasives, as they will damage
the finish.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3 years of age.
MARBUZET LINEAR SCONCE 25"
