Ridefarr Arm Rest Kit User manual

INSTRUCTION MANUAL
[e-mail]
TOOLS REQUIRED:
• 1 X T25 KEY • 1 X 5mm ALLEN KEY
ARM REST KIT
ASSEMBLY DIAGRAM
DESCRIPTION MATERIAL WEIGHT (g) QTY
ITEM
1.
2.
3.
4.
5.
6.
7.
8.
AERO BOLT-ON CARBON CARBON 1
1
1
6
2
2
2
4
75.8
3.3
3.3
3.2
56.6
56.6
14.7
26.3
STEEL
AL6061
AL6061
STEEL
NYLON INJECTION
EVA
BOLT T25 - M5 X 16MM
CLAMP
L BRACKET
BOLT M6 X 12MM
ARM REST - LEFT
ARM REST - RIGHT
PAD
NYLON INJECTION
IMPORTANT NOTICE :
CLAMP BOLTS FROM THE AERO BOLT-ON MUST BE
REPLACED WITH T25 M5 X 16mm BOLTS SUPPLIED.
8.
5.
6.
2.
3.
3.
4.
4. 7.
5.
8.
1.
DISCLAIMER : INCORRECT ASSEMBLY AND/OR USE COULD CAUSE FAILURE AND INJURY.
PRODUCT IS INTENDED FOR USE ON SMOOTH ROADS ONLY. ITEM IS NOT FOR COMPETITION USE.

STEP 5:
ATTACH THE NEW CLAMPS WITH THE SUPPLIED M5 X 16mm BOLTS
SUPPLIED WITH THE ARM REST KIT.
NOTE:
BOTH LEFT AND RIGHT NEED TO BE POSITIONED AT THE SAME HEIGHT
ON THE L-BRACKET ADJUSTMENT. CHECK TO MAKE SURE THE CUPS
WILL CLEAR THE TOP OF THE HANDLEBAR.
STEP 6:
TURN HANDLEBAR AROUND AND CHECK THAT THE CUPS ARE WELL POSITIONED AND ALIGNED EVENLY. ENSURE LEFT AND RIGHT SIDE ARE
THE SAME POSITION.
STEP 7:
ATTACH THE LEFT AND RIGHT PADS SUPPLIED.
STEP 2:
ASSEMBLE THE L-BRACKETS TO THE CLAMPS USING THE
SUPPLIED M5 X 16mm BOLTS
NOTE:
THERE ARE 2 HOLES FOR ADJUSTMENT OF THE L-BRACKET
HEIGHT. SELECT THE PREFERRED HEIGHT BASED ON HANDLEBAR
/ STEM SETUP ON THE BIKE.
STEP 1:
REMOVE LOWER CLAMPS AND BOLTS SUPPLIED WITH AERO BOLT-ON
NOTE:
THE CLAMPS AND BOLTS ARE REPLACED WITH SUPPLIED ITEMS IN THE KIT
STEP 4:
ATTACH THE NEW CLAMPS WITH THE SUPPLIED M5 X 16mm BOLTS SUPPLIED WITH THE ARM REST KIT.
NOTE:
BOTH LEFT AND RIGHT NEED TO BE POSITIONED AT THE SAME HEIGHT ON THE L-BRACKET ADJUSTMENT.
CHECK TO MAKE SURE THE CUPS WILL CLEAR THE TOP OF THE HANDLEBAR.
STEP 3:
PLACE AERO BOLT-ON ON THE HANDLEBAR –
YOU WILL NEED TO ACCESS THE UNDERSIDE OF THE BOLT-ON TO
ASSEMBLE THE NEW CLAMPS