Rife CT1200 Quick setup guide

Rife Technologies
Crank Height Adjustable Desk
CT1200
WWW.rifeindia.com
Tel : [phone]
ASSEMBLY & USE INSTRUCTIONS

Parts List
Part
Components
Qty
1
Table board
2
2
Crossbar Rail
2
3
Connecting Link
1
4
Side Bracket
2
5
Lift Column
2
6
Foot
2
7
Handle Connecting
1
8
Handle
1
9
Leveling Feet
4
10
Machine Screws: M6*12
20
11
Wood Screws: ST5*16
16
12
Wooden pin
4
13
4mm Allen Key
1
14
2.5mm Allen Key
1

STEP 1
Lay out all components and hardware to ensure that you have all components and
hardware listed on the parts page .
STEP 2
Position two Crossbar rails (#2) on its side.
Place one Lift column (#5) on the
Crossbar rails.. Line up the holes on the
Lift column with the holes on each
Crossbar rails.
Insert four M6 x 12 screws ( #10) and
tighten them.
Position one Side bracket (#4) on the leg
side as shown .
Insert two M6x12 screws (#10) and
tighten the screws.
STEP 3
Attach a Foot (#6) with four M6x12 Machine
Screws (#10) and tighten screws in a cross pattern.
Position two Leveling feet (#9) on the foot and
tighten them.

STEP 4
Position the Connecting link (#7) in the middle of the desk base, adjust its length and
tighten the screws on the Connecting link.
Slightly loosen the screws at A and B with the 2.5mm Allen key (#14)（do not remove
the screws）
Before inserting the Hex Drive Shaft into the left column make sure that both lift
columns are sitting flat on the ground and are the same height. If they are not sitting flat
and even at the same height the frame will lift uneven.
Slide the HEX bar out from the link and insert it into the right side lifting column C and
D.

STEP 5
Position the Handle Connecting(#7) and Handle (#8) as shown.
SETP 6
Connect the table board(#1) with four wooden pins(#12) as shown.

STEP 7
Confirm the desk frame is properly positioned on the underside of the table board .
Attach the desk frame to the underside of the table board by using twelve ST5x16 wood
screws (#11).
Adjust the length of the Handle connecting (#7) as per desktop length, tighten the screw
on the Handle connecting .
Attach the Handle connecting (#7)to the underside of the desktop as shown by using four
ST5x16 wood screws (#11).