Ring Automotive RAC900 User manual


AIR COMPRESSOR
RAC900



Before operang this compressor, please read and become familiar with the enre
instrucon leaet and retain for future reference

3
Unless direcons are followed, physical injury or property damage may result. When
using the compressor ensure you are parked in a safe locaon, o the road with the
car handbrake on and your personal safety is not at risk. The Compressor must not
be used when the vehicle is moving. Never leave the compressor unaended. When
the compressor is not in use store in the bag provided.
• Power required 12 volts DC rated at 23 amps DC
• This compressor is not designed for extended use. Operaon over an extended
period of me will overheat the unit and damage the compressor. It is should not
be used connuously for more than 30 minutes. Aer 30 minutes, turn it o and
let it cool for 15 minutes before resuming operaon.
• If the compressor is making an abnormal sound, or the temperature of the unit
is too high, turn the power o immediately and let it cool for at least 30 minutes
before resuming operaon.
• Do not use the air compressor on high pressure tyres such as those used on
commercial vehicles, agricultural or specialist vehicles.
• Ensure that the device is stored in a dry place.
• Do not allow the compressor to be posioned close to inammable liquids or
gases. Do not allow the compressor to become wet.
• Only use the adapters supplied with the device.
• Refer to your vehicle’s hand book for the relevant tyre pressure
• Only use the adapters supplied with the device.
• Refer to your vehicle’s hand book for the relevant tyre pressure


4
• Ensure the ON/OFF switch is in the OFF posion
• Connect the clips to the baery i.e.
- Red (posive +) clip to the Red (posive +) baery terminal.
- Black (negave -) clip to the Black (negave -) baery terminal.
• Connect the yellow air hose to the short black hose on the compressor. Pull back
the collar on the brass xing and connect.
• Screw the valve connector clockwise onto the tyre valve stem. Ensure the
connector is well connected with the stem, but do not over ghten.
• Depress the ON/ OFF buon to switch the device ON and inate to the desired
pressure.
• Stop inaon to take a pressure reading.
The inline pressure gauge is designed to provide
accurate pressure readings within a ±3% tolerance. Please note that during inaon
and deaon, due to air velocity the pressure gauge cannot provide accurate readings.
Momentarily halt inaon or deaon to obtain accurate pressure readings.

• Screw the valve connector clockwise onto the tyre valve stem. Ensure the
connector is well connected with the stem, but do not over ghten.
• Push the black grip towards the valve to deate.
•
For hands free deaon push the black grip towards the valve and twist ¼ turn to lock.
• Twist back to release.
• Stop deaon to take a pressure reading.


5

• Inspect compressor before each use. Do not use the compressor if bent, broken,
melted, burnt, wet, or any of the components are damaged.
• Do not kink or block the air hose while the compressor is working
• If using the vehicle baery take care to ensure enough power is retained within
the baery to start the vehicle aer inaon


The RAC900 Heavy Duty Air Compressor comes with a standard 12 month guarantee.
Register your purchase either on the below form or via the Ring Automove website and
you will receive an addional 12 months protecon free.

This guarantee provide benets which are addional to and do not aect your other
legal Rights. Ring Automove will replace either the product or the accessories which
are shown to the sasfacon of Ring Automove to be defecve due to faulty materials
within 12 months from the date of purchase (or 24 months if you have registered for the
extended guarantee of 2 years within 4 weeks from the date of purchase. This guarantee
shall not cover any fault or defect caused by:-
• Faults from failure to observe the product instrucons
• Careless operang handling or misuse
• External sources e.g transit damage; or
• Repairs or alteraons carried out by pares other than Ring Automove
•
The use of non approved Ring accessories or any other accessories not supplied with the product.
This guarantee shall not apply to nor cover any other claims whatsoever. It will in
parcular not cover any claims for conversion or modicaon or for the costs of repairs
carried out by any third party without the prior consent of Ring Automove.
If you want to claim under this warranty you must send the air compressor to Ring
Automove Ltd together with the original purchase receipt clearly showing the purchase
price and the store where it was purchased. For your protecon we recommend that all
returns be send by registered post or recorded delivery.
     
12V 280W 150PSI 23Amp 30Amp

6
All secons must be completed and return to:

AIR COMPRESSOR

Title:
First Name:
Surname:
Address:
Town: Post Code:
Purchase Date: Purchase Price:
Purchase From:




[phone]
[phone]
autosales@ringautomove.com
www.ringautomove.com L272