Ritek R6 User manual
For iPhone user:
How to establish the connection between iPhone and R6 / Q-77HR?
Ans:
iOS
Requires iOS 7.0 or later
iPhone 4S / 5 / 5S / 5C / 6 / 6 plus / 6S / 6S plus
iPad (3rd & 4th generation)
iPad Air (all models)
iPad mini (all models)
iPod touch (5th generation)
(1). Please search and install My Fit Log Life app from your iPhone App Store:
You may also download from our website: http://appstore.com/myfitlog
(2). Please make sure your R6 / Q-77HR is fully charged before connecting with it.
Note: R6 / Q-77HR has power protective design before the connection. It has to be fully charged, otherwise it
cannot be connected and prompted firmware upgraded.
(3). Please open My Fit Log Life app on your iPhone, and enable Bluetooth function.
(4). First time install the My Fit Log Life, please click "Yes. First Time" to start the installation.
If you have installed this R6 / Q-77HR with any other phone before, please click "No, Not first time"
(5). Please make sure your R6 / Q-77HR is fully charged when used for the first time.
It takes about 2 hours before it is fully charged.
If you select "No, Not first time", please continue to do "Check Device Status" and "Reset Device Settings"
[Check Device Status]
Please switch R6 / Q-77HR to Daily mode, and make sure the signal strength icon does not appear.
[Reset Device Settings]
Reset your R6/Q-77HR device.
(6). Please press the button on your R6 / Q-77HR to turn on device and make it visible for devices scan via
Bluetooth connection.
When Bluetooth searched R6 / Q-77HR, please click on it. It will be connected automatically.
Note:
1. If your phone Bluetooth cannot search R6 / Q-77HR, please click the R6 / Q-77HR button once and then
back to App and scan again. If it still does not search anything, please charge your R6 / Q-77HR for 10
seconds to remove power protective mode... and scan again.
2. R6 / Q-77HR will connect to server and check the firmware version when the R6 / Q-77HR has first
connected with phone successfully, please make sure Wi-Fi or 3G network of your phone has been turned
on.
(7). After your R6 / Q-77HR and iPhone connected, please press the button on R6 / Q-77HR twice in 30 seconds
to confirm your R6 / Q-77HR.
(8). When R6 / Q-77HR is connected, it will show its Serial Number and firmware version.
(9). Please fill your personal information when using for the first time.
(10). My Fit Log Life will auto-detect the firmware of R6 / Q-77HR,
please click "Upgrade" to upgrade to the latest version.
(11). When upgrading the firmware, it needs to take around 10~15 minutes. Please be patient to wait and not to
close the app.
(12). R6 / Q-77HR is set up successfully.
(13). If you would like to transfer the notification from phone to your R6 / Q-77HR, please click "OK" to enable
the Notification function.
(14). Please click "Pair" to make sure the Bluetooth connection between R6 / Q-77HR and your phone.
Then the My Fit Log Life app will go into the main page of the app, it will show "Connected" on the left top.
You can start to use My Fit Log Life.
If your R6 / Q-77HR is touch screen, please continue to practice the mode switching,
please follow the steps to practice, and click "Exit" to go back to main page.
