RM Italy BLA600 Manual

RM Italy BLA-600
Disassembly Procedure
With a TORX (TX10) screwdriver unscrew the right had
side screw underneath the warranty seal.
With a TORX (TX10) screwdriver, unscrew the left hand
screw near the AC input connector.
Pull out the panel to extract the voltage change system
with the corresponding cables.
With pliers, remove all the numbered cables from the
panel. Do not pull the cables to disconnect the
connector.
At this point you should find the panel as in the
picture. Now you are ready to set the AC input voltage
of the amplifier.

RM Italy BLA-600
115VAC Setup
At this point you should find the panel as in the photo.
Now you are ready to set the AC input voltage of the
amplifier.
Connect cable "1" to one of the spade lugs labelled "A"
Connect cable "2" to one of the spade lugs labelled "D"
Connect cable "3" to one of the spade lugs labelled "A"
Connect cable "4" to one of the spade lugs labelled "D"
Connect cable "5" to one of the spade lugs labelled "B"
Connect cable "6" to one of the spade lugs labelled "C"

RM Italy BLA-600
230VAC Setup
At this point you should find the panel as in the photo.
Now you are ready to set the AC input voltage of the
amplifier.
Connect cable "1" to one of the spade lugs labelled "A"
Connect cable "2" to one of the spade lugs labelled "B"
Connect cable "3" to one of the spade lugs labelled "B"
Connect cable "4" to one of the spade lugs labelled "D"
Connect cable "5" to one of the spade lugs labelled "C"
Connect cable "6" to one of the spade lugs labelled "D"

RM Italy BLA-600
240VAC Setup
At this point you should find the panel as in the photo.
Now you are ready to set the AC input voltage of the
amplifier.
Connect cable "1" to one of the spade lugs labelled "A"
Connect cable "2" to one of the spade lugs labelled "B"
Connect cable "3" to one of the spade lugs labelled "B"
Connect cable "4" to one of the spade lugs labelled "C"
Connect cable "5" to one of the spade lugs labelled "C"
Connect cable "6" to one of the spade lugs labelled "D"

RM Italy BLA-600
Supply Voltage and Fuse Information
Supply Voltage information:
Supply Voltage 50/60 Hz 1200VA max
120 Vac +/- 5%
230 Vac +6%, -10%
240 Vac +10%, -6%
When making a change to the input voltage, the input Fuse must also be changed:
AC Input Fuse 5 x 20 mm F LBC 250V (Fast Blow)
115 Vac Supply 10A
230 Vac Supply 6A
240 Vac Supply 5A
RM Italy BLA-600 Input Voltage Set Up and Voltage/Fuse Information
Courtesy of DX Engineering - 16 August 2018
DX Engineering - 1200 Southeast Ave. - Tallmadge, OH 44278 USA - Phone [phone]