Roberts 3-band Battery Portable Radio R9924 User manual

ROBERTS
Sound for Generations
R9924 3-band battery portable radio

1
2
3
1. Tuning LED
2. Power indicator
3. Tuning scale
Controls

If you need any further advice, please call our Technical Helpline
on :- 020 8758 0338 (Mon-Fri)
5
6
8
7
49
4. Telescopic aerial
5. Volume control
6. Headphone socket
7. Waveband switch
8. Tuning control
9. Battery compartment

1. Open the Battery cover on the rear of your
radio pushing the catch in and downwards
just above the word ‘Open’.
2. Insert two LR6 (AA size) batteries into the
spaces in the compartment. Take care to
ensure all batteries are inserted with the
correctpolarityasshown.Close thebattery
cover.
3. Reduced power,distortion, anda‘stuttering’
sound are all signs that the batteries may
need replacing.
Inserting batteries

If you need any further advice, please call our Technical Helpline
on :- 020 8758 0338 (Mon-Fri)
1. Switch on yourradiobyrotatingtheVolume
control clockwise until a click is heard.The
Power indicator will appear.
2. Set theWaveband selector totherequired
waveband.
3. Adjust the Volume control until a hissing
sound is heard.
4. Rotate the Tuning control to select the
desired station. The Tuning indicator will
light when the station is correctly tuned. On
MW and LW the Tuning scale is marked in
kilohertz (kHz). On FM the Tuning scale is
marked in Megahertz (MHz)
Operating your radio

5. For MW and LW reception rotate your radio
to the position giving best reception.
6.For FM reception fully extend the
Telescopic aerialandthenangleandrotate
for best reception.
6. Adjust the Volume control to the required
sound level.
7. To switch off your radio rotate the Volume
control fully anticlockwise until a click is
heard.
Note : The telescopic aerial is inoperative
on MW and LW.

If you need any further advice, please call our Technical Helpline
on :- 020 8758 0338 (Mon-Fri)
1. A Headphone Socket (3.5mm) located on
the left hand side of your radio is provided
for use with either headphones or an
earpiece. Inserting the headphone plug
automatically mutes the internal
loudspeaker.
Headphones

General
Do not allow this unit to be exposed to water
orsteam.Itis recommended that the FM band
be used wherever possible as better results
in terms of quality and freedom from
interference will usually be obtained than on
the MW or LW bands.

If you need any further advice, please call our Technical Helpline
on :- 020 8758 0338 (Mon-Fri)
Specifications
Batteries 2 x LR6 (AA size)
Battery Life Approx. 60hrs of listening for 4
hours a day at normalvolume
using alkaline cells.
Frequency Coverage
FM 87.5-108MHz
MW 530- 1710kHz
LW 148- 284kHz
Loudspeaker57mm
Output Power
50 mW into 8ohms
Headphone socket
3.5mm dia
Aerial System
FM Telescopic aerial
MW Built-in Ferrite aerial
LW Built-in Ferrite aerial

Notes