Roberts R9954 User manual

R9954
3BandMainsBattery
PortableRadio
Please read this manual before use
ROBERTS
SoundforGenerations

2
Contents ............................................................................2
Controls ..........................................................................3-4
Battery Operation ..............................................................5
Mains Operation ................................................................5
Operating your radio - FM .................................................6
Operating your radio - Medium and Long wave ................7
Favourite station markers.................................................8
Headphones ......................................................................8
Specifications....................................................................9
General ............................................................................10
Mains supply....................................................................10
Guarantee........................................................................ 11
Contents

Controls
3
1. On/Off button
2. Waveband buttons
3. Telescopic aerial
4. Tuning control
1
5. Dialpointer
6. Favourite station markers
7. Tone control
8. Volume control
2
(Top)
3
45
6
78

4
9. Battery compartment
10. Mains socket
11. Headphone socket
910
11
Controls (Rear) (End)

If you need any further advice, please call our Technical Helpline on :-
02087580338(Mon-Fri)
Battery operation
1. Remove the Battery cover on the rear of the unit by pushing the
battery door in and downwards.
2. InsertfourLR14(Csize)batteriesintothespacesinthecompartment.
Takecare toensure allbatteriesareinsertedwith thecorrect polarity
as shown inside the battery compartment. Replace the battery
cover.
3. Reduced power, distortion and a ‘stuttering’ sound are all signs that
the batteries may need replacing.
4. If the radio is not to be used for any extended period of time it is
recommended that the batteries are removed from the radio.
We would recommend for economy that the R9954 is used on the
mains whenever possible with battery operation for occasional or
stand-by use only.
Mains operation
1. Place your radio on a flat surface.
2. PlugthemainsleadintotheMainssocketlocatedontherearofyour
radio ensuring that the plug is pushed fully into the socket.
3. Plug the other end of the mains lead into a wall socket and switch
on the wall socket.
5
1

6
Operating your radio - FM
1. Switch on your radio by pressing the On/Off button.
2. Press the FM button to select the FM waveband.
3. Adjust the Volume control until a hissing sound is heard.
4. Rotate the Tuning control to select the desired station. On FM the
Tuning scale is marked in Megahertz (MHz).
5. For FM reception fully extend the Telescopic aerial and then angle
and rotate for best reception
6. Adjust the Volume to the required setting.
7. Adjust the Tone control to the required setting.
8. To switch off your radio press the On/Off button.
2
1
34
8
67 5

If you need any further advice, please call our Technical Helpline on :-
02087580338(Mon-Fri) 7
Operating your radio - Medium and Long wave
1. Switch on your radio by pressing the On/Off button.
2. Press either the MW or LW button.
3. Adjust the Volume control until a hissing sound is heard.
4. Rotate the Tuning control to select the desired station. On MW
and LW the Tuning scale is marked in kilohertz (kHz).
5. For MW or LW reception rotate your radio to the position giving best
reception.
6. Adjust the Volume to the required setting.
7. Adjust the Tone control to the required setting.
8. To switch off your radio press the On/Off button.
Note : The telescopic aerial does not operate on MW and LW.
8
67
12
34
5

Headphones
1. A Headphone Socket (3.5mm) located on the left hand end of
your radio is provided for use with either headphones or an
earpiece. Inserting the headphone plug automatically mutes the
internal loudspeaker.
8
Favourite station markers
1. Your radio is fitted with 3 favourite station markers which allow up
to 3 stations to be quickly located.
2. Tune into the required station.
3. Positiononeofthemarkerssothatitappearsontopofthedialpointer.
Whenever you wish to return to that station simply line up the dial
pointer with the corresponding marker.
4. Repeat the above procedure for the 2 remaining favourite station
markers.
1
2

If you need any further advice, please call our Technical Helpline on :-
02087580338(Mon-Fri) 9
The Company reserves the right to amend the specification without notice.
Specifications
Power Requirements
Mains AC 230 volts, 50Hz only
Batteries 4 x LR14 (C size)
Battery Life
Approx. 80hrs of listening time for 4 hours a day at
normal volume using alkaline cells.
Frequency Coverage
FM 87.5 - 108MHz
MW 522 - 1620kHz
LW 144 - 281kHz
CircuitFeatures
Loudspeaker 92mm x 1 ohm
Output power 1W into 4 ohms
Headphone socket 3.5mmdia.
Aerial System FM Telescopic Aerial
MW Built-in Ferrite aerial
LW Built-in Ferrite aerial

10
The wire coloured BLUE must be connected to the terminal marked N or
coloured BLACK.
The wire coloured BROWN must be connected to the terminal marked
L or coloured RED.
General
Donotallowthisunittobeexposedtodrippingorsplashing.Donotleave
your radio where excessive heat could cause damage such as in a
parked car where the heat from the sun can build up even though the
outside temperature may not seem too high. It is recommended that the
FMbandbeusedwhereeverpossibleasbetterresultsintermsof quality
and freedom from interference will usually be obtained than on the MW
or LW bands.
Mainssupply
The R9954 will operate from a supply of AC 230 volts, 50Hz only.
DO NOT cut off the mains plug from this equipment. If the plug
fitted is not suitable for the power points in your home or the cable is too
shorttoreacha power point, then obtain an appropriate safety approved
extension lead or adaptor. If in doubt consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and dispose
of the plug immediately to avoid a possible shock hazard by inadvertent
connection to the mains supply.
If this product is not supplied with a mains plug, or one has to be fitted,
then follow the instructions given below:
IMPORTANT.DONOTmakeanyconnectiontothelargerterminalwhich
is marked with the letter E or by the safety earth symbol or coloured
Green or Green-and-yellow.
The wires in the mains lead are coloured in accordance with the
following codes :-
BLUE - NEUTRAL BROWN - LIVE
Fuse
When replacing the fuse only a 3A ASTA approved to BS1362 type
should be used and be sure to re-fit the fuse cover.
IFINDOUBT-CONSULT A QUALIFIEDELECTRICIAN.
Replacement fuse holders are available from Roberts Radio Technical
Services at the address shown on the rear of this manual.
Nameplate
The Nameplate is located on the underside of your radio.

11
Guarantee
Thisinstrumentisguaranteedfortwelvemonthsfromthedateofdeliveryto theoriginalowneragainstfailureduetofaultyworkmanship orcomponent
breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced
free of charge.
The guarantee does not cover: 1. Damage resulting from incorrect use.
2. Consequential damage.
3. Receivers with removed or defaced serial numbers.
N.B. Damaged or broken telescopic aerials will not be replaced under guarantee.
Procedure:
Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your Roberts' dealer
will be able to attend to any defect quickly and efficiently, but should it be necessary the dealer will return the instrument to the company’s service
department for attention. In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was purchased, please
contact Roberts Radio Technical Services at the address shown on the rear of this manual.
These statements do not affect the statutory rights of a consumer.

ROBERTS RADIO TECHNICAL SERVICES
97-99WortonRoad
IsleworthMiddlesex
TW76EG
Technical Helpline:- 020 8758 0338 (Mon-Fri)
Issue 1