ROCAM CR1001E User manual

- 02 -- 01 -
Chapter 1 LOCATION OF CONTROLS
20
17 19 18
21
9
12345678
13
14
10
11
12
15
16
1.Set Time Button 2.Hour Button 3.Minute Button
4.Dimmer Button 5.SNOOZE Button 6.Alarm Pause Button
7.Alarm OFF Button 8.Alarm 1 Button 9. Alarm 2 Button
10. PM Indicator 11.Alarm 1 Indicator
12.Alarm 2 Indicator 13.DST Indicator
14.12/24H & DST Button 15.Volume + Button
16.Volume - Button 17.Battery Door
18.USB Port 19.DC Jack
20.Speaker 21.Holder ( x 2pcs)
Note: Battery is not included
Chapter 2 POWER RESOURCES
1. Install 2pcs 1.5V “AAA” size batteries to the proper terminals in
the battery compartment to memorize the time setting in case
of power outage.
NOTE: Batteries(not included) don't support time display but can back up
time & alarm setting and trigger an alarm in case of AC power failure.
2. Connect the adapter line to DC jack , then plug into a 100~240V
AC wall power outlet.
Chapter 3 TIME SETTING
SET
TIME
HOUR MIN
SET
TIME
12/24H &DST
1. Press button once, display starts flashing.
2. Press button to set the hour. press button to set
the minute.
3. Press button or button to save time or wait
for another 5 seconds to confirm automatically.
To change 12H/24H time format
Press button to change 12H/24H time format.
ROCAM
R
CR1001E Alarm Clock with USB Charger
CREATE YOUR PERFECT SLEEP ENVIRONMENT Version 1.0
Mad e in China
Http://www.yelaw.net
[email protected]
Speak with our Experts
[phone]
Mon-Fri: 9:00am ~01:00pm PST
8:00am ~12:00pm PST
SNOOZE

- 05 - - 06 -
- 04 -- 03 -
Chapter 3 ALARM SETTING
1
1
Turn off Alarm
When alarm goes off:
1. Press button to temporarily turn off alarm for 9
minutes. Alarm will ring every next 9 minutes.
2. Press button to turn off alarm for 24 hours.
The alarm indicator or is still on, which means
alarm is still activated and will ring after 24 hours.
3. Cancel Alarm
Press button to turn off alarm1 or alarm 2 permanently.
And corresponding indicator or will turn off.
If alarm 1 goes off, then press button, just turn off
alarm1 permanently. indicator (11) will turn off .
If alarm 2 goes off, then press button, just turn off
alarm 2 permanently. indicator (12) will turn off.
2
1. Press button, the alarm indicator (11) will light up,
the display starts flickering.
2. Press button to set the hour, press button to set
the minute.
3. Press button or button to save alarm time or
just wait for another 5 seconds to confirm automatically.
4. Push or button to adjust alarm volume.
Setting ALARM 2 is the same as ALARM 1.
ALARM
11
VOL+ VOL-
HOUR MIN
ALARM
1
2
ALARM
OFF
ALARM
OFF
ALARM
OFF
ALARM
PAUSE
Chapter 6 USB CHARGING
Plug charging cable into device such as phone or tablet.
Device can charge both your phone or tablet at the same time.
The maximum charge current is 1 Ampere.
22:23
2
89%
E
E
1
Chapter 4 DIMMER
Repeat button to adjust the brightness of display for your
preference.
There is 5 levels, The sequence is as follows:
01-02-03-04-05-04-03-02-01........
DIMMER
12/24H &DST
Hold press button to switch DST function.
DST indicator will turn on.
Hold press button again to turn off DST function.
DST indicator will turn off.
Chapter 5 DST
12/24H &DST
1 2
SNOOZE
SNOOZE