RF-MONO70C
I
70" Carbon Fiber Monopod
Quick Setup Guide
# Component Description
1 Quick-release mounting plate Mount your device to this removable plate.
2 1/4" screw Tighten to secure your device to the mounting plate.
3 Mounting base plate Clamp the quick-release mounting plate to this base plate.
4 Variable angle head ball Allows the head to be adjusted to any angle.
5 Safety lock pin Prevents the mounting plate from falling out when the quick
release clamp knob is released.
6 Pan locking knob Locks the horizontal movement of the head.
7 Quick-release plate locking knob Locks the quick-release mounting plate to the tripod.
8 Head ball locking knob Sets the head at dierent angle. Loosen to permit movement
of the head ball. Tighten to stop movement of the head ball.
Package contents
• Monopod with pan head
• Mounting plate
Note: mounting plate is on the pan head.
• Wrench (1)
• Quick Setup Guide
Important safety instructions
• Make sure that all levers, handles, knobs, and leg locks are correctly
tightened before use.
• Do not carry or transport the monopod with camera equipment attached
(for example, over your shoulder or cradled in your arms).
• Do not store or expose your monopod to excessive heat or cold, or use near
any ame or re.
• Do not oil or grease any part of the monopod.
• Do not use any solvents or thinners to clean your monopod.
Use only a mild detergent and wipe dry with only a soft, lint-free cloth.
• Do not exceed the load limit of this product. (See Specications)
Features Using your monopod
To set up your monopod:
1Unscrew the leg locks and extend the leg to the desired
length.
2Tighten the leg locks to adjust the monopod to the desired
height.
Caution: Incorrectly securing a leg lock can cause the
monopod leg to retract unexpectedly and could result in
damage to the monopod or to the attached camera or
camcorder.
3To remove the mounting plate, unscrew the quick-release
plate locking knob, then press the safety lock pin and lift the
plate away from the head.
4Secure your camera or camcorder to the mounting plate
with the 1/4" screw on the bottom of the plate. Tighten the
screw rmly to avoid unintended lateral movement of your
device.
Specications
One-year limited warranty
Visit www.rocketshproducts.com for details.
Contact Rocketsh:
For customer service please call 1-800-620-2790
www.rocketshproducts.com
Distributed by Best Buy Purchasing, LLC
7601 Penn Avenue South, Richeld, MN 55423-3645 USA
© 2010 BBY Solutions, Inc., All Rights Reserved. ROCKETFISH is a trademark of BBY
Solutions, Inc. All other products and brand names are trademarks of their
respective owners.
ENGLISH 10-0540
Minimum Maximum Maximum Maximum
Folded operating operating tube Net load
Model height height height diameter weight capacity
RF-MONO70C 22.8 in 22.8 in 70 in 1.14 in 1.82 lbs. 20 lbs.
(579 mm) (579 mm) (1778 mm) (29 mm) (820 g) (9 kg)
