Rockville RMC65L User manual

RMC65L / RMC80L
MARINE LED SPEAKER USER’S MANUAL

2
This unit accepts 5V to 24V power supply. Connect the red cable
to the positive (+12V) terminal of your power supply or to an
accessory line. Connect the black cable to closest part of the
vehicle chassis.
Connect the male plug extending from one of the
speakers to the female end of one of the cables
extending from the controller (a). Connect the
male end of the included extension cord to the to
the female end of the other cable extending from
the controller (b). Now connect the female plug
of the extension to the male plug extending from
the other speaker (c).
LED CONTROLLER WIRING INSTRUCTIONS
This LED controller module supports LED products that feature
common anode connections. The black triangle with the plus sign
inside indicates the common connection anode. The peak output
current is 4 amps per channel. If the main unit is overheating,
please reduce the load.
CAUTION!
Do not short circuit the led output. Doing so may cause permanent damage!
PLEASE NOTE
• Use 18 gauge or thicker wire for power and ground connections.
• Anode connection is common positive.
a
c
b

3
1. Turn On / Standby: Press this key to turn on LEDs or switch to standby mode.
2 / 9. Dynamic Mode: Switch from dynamic mode to color mode or switch between dy-
namic modes.
3 / 8. Dynamic Mode Speed: Use these buttons to adjust dynamic mode speed. If the unit
is in static mode, pressing these buttons will switch unit to dynamic mode.
4 / 5. Static Color Adjust: Use these button to switch between static colors. Pressing
these keys while in dynamic mode will switch the unit to static mode.
6 / 7. Brightness Adjust: Pressing these buttons will adjust brightness while in static
mode. If these buttons are pressed while unit is in dynamic mode, it will switch to static
mode.
10. Demo Mode button: this button will switch the unit into demo mode. While in demo
mode, unit will loop through 17 dynamic modes with each repeating 3 times.
11. Direct Color Select button: press these buttons to select specic static colors. You
can also use the Static Color Adjust buttons to select static colors.
• Please remember to remove plastic insulator from remote unit battery compartment.
• This remote uses a 3 volt CR2025 type battery. Replace with the same type of battery.
• The remote signal can pass though most obstacles.
• Don’t install unit in areas surrounded by metal as the remote signal will not reach the unit.
REMOTE CONTROL FEATURES

Visit us at:
RockvilleAudio.com
Due to constant improvements, these specications are subject to
change without notice.
Copyright 2020