Rogers Smart Home Monitoring User manual

In-Wall Switch
or In-Wall Dimmer
Manufacturer's Installation Guide

2 Smart Home Monitoring | In-Wall Switch or In-Wall Dimmer | Manufacturer's Installation Guide
Installation Configurations
This switch may be used in new installations or to replace an existing wall switch.
It may be used in the following configurations:
›By itself for 2-way control (one switch & one load)
›By adding one Jasco Auxiliary Switch for 3-way control (two switches & one load)
›By add two Jasco Auxiliary switches for 4-way control (three switches & one load)
When used by itself for 2-way control, please make sure that the screw terminal for the
traveler wire is insulated. Do not remove the tape over the terminal if you are not using
the traveler connection.
This dimmer switch is designed for use with permanently installed lighting fixtures only.
The switch has been optimized for use with incandescent lighting as well as with most
dimmable CFL and LED bulbs. The maximum load ratings for this switch are 600W for
incandescent bulbs and 150W for dimmable CFL and LED’s. Lighting controlled by this
switch must not exceed these stated limits.

3 Smart Home Monitoring | In-Wall Switch or In-Wall Dimmer | Manufacturer's Installation Guide
Wiring Diagrams

4 Smart Home Monitoring | In-Wall Switch or In-Wall Dimmer | Manufacturer's Installation Guide
Single, Dual and Triple Gang Boxes
When installing the In-Wall On/O switch in multiple
gang boxes it may be necessary to break o one or
both of the scored tabs on the front yoke.
Wiring Instructions
1. Shut o power to the circuit at circuit breaker or
fuse box.
Warning: Verify power is OFF to switch box before
continuing.
2. Remove wall plate.
3. Remove the existing switch's mounting screws.
4. Carefully remove the existing switch from the
switch box. DO NOT disconnect the wires.
5. There are up to five screw terminals on the
existing switch; these are marked
A. LINE (Hot) — Black (connected to power)
B. Neutral — White
C. LOAD — Black (connected to lightning)
D. GROUND — Green/Bare
E. TRAVELER — Red/Other
Match these screw terminals to the wires connected
to the existing switch.
6. Disconnect the wires from the existing switch.
Be careful to label wires according to the
previous terminal connection.

5 Smart Home Monitoring | In-Wall Switch or In-Wall Dimmer | Manufacturer's Installation Guide
The Jasco Auxiliary switch is required for Multi-Switch 3-way or 4-way installations.
Connecting the traveler terminal of this switch to a standard, non-Jasco switch will cause
damage or result in improper function. If this switch is a part of a 3-way or 4-way multi-
switch installation, do not connect the traveler wire or apply power until Jasco Auxiliary
switches are correctly installed. For more information on 3-way or 4-way installations, view
the manual or quick-start guide that comes with the Jasco Auxiliary switch.
7. Connect the green or bare copper ground wire
to the GROUND terminal.
8. Connect the black wire that goes to the light to
the terminal marked LOAD.
9. Connect the black wire that comes from the
electrical service panel (Hot) to the terminal
marked LINE.
10. Connect the white wire to the neutral terminal.
Note: UL specifies that the tightening torque for the
screws is 14 Kgf-cm (12 lbf-in). The Traveler terminal is
only used for 3-way or 4-way wiring and should
remain insulated if the switch is being installed in a
2-way system (one switch & one load).
11. Insert Switch into the switch box being careful
not to pinch or crush wires.
12. Secure the switch to the box using the supplied
screws.
13. Mount the wall plate.
14. Reapply power to the circuit at fuse box or circuit
breaker and test the system.