INSTALLATION GUIDE
Please register your product at www.rosewill.com for complete warranty information and support for your product. RMS-19044_A
1
4
When lifting the table, be sure to hold the bottom with both
hands. Do not subject the table to a separate force. This can
cause the tabletop to be out of step with the bottom structure.
2 3
Press to adjust height
Hands must not exceed safety shield
below the tabletop, otherwise it will pinch.
Step-less height
adjustment
Keep monitor and
laptop base fully on the
worksurface. Allowing any part
of base or stand to hang off the
edge may result in property
damage and/or personal injury.
Raise worksurface slowly.
Raising worksurface too
fast may create an unstable
situation resulting in property
damage and/or personal injury.
To avoid the potential of
pinching cables, it is
important to follow the cable
routing instructions in this
manual. Failure to follow these
instructions may result in
equipment damage and/or
personal injury.
Leave enough slack in
cable to allow for full
range of vertical motion (16.7 in
/ 42.4 cm). Failure to heed this
warning may result in property
damage and/or personal injury.
Step 1
Step 2
