Roswell Moomba User manual

Vamp Spin Speaker
Installation Instructions
Speaker Hardware
Pg. 1/2
THREADLOCKER
Tools Required
Wire Strippers
& Crimps 5/16” Allen Key
Phillips
Screw Driver
Deutsch
Wiring Harness x2
NOTES
*BEFORE WIRING ANYTHING PLEASE MAKE SURE YOUR BOAT, DECK, AND AMP ARE ALL TURNED OFF*
Pencil
Safety Lanyard x2
x6 x2
Rev. 28-May-15
A
B
• You will need to connect the included 20” Deutsch wiring harnesses to your tower
wires according to the chart in STEP B. Please note the Black and Blue wires of the
wiring harnesses are not used in this installation
Wiring Diagram
Port
Starboard
Function
Port Speaker +
Port Speaker –
Function
Stbd Speaker +
Stbd Speaker –
Speaker Wire
White
White/Black
Speaker Wire
White
White/Black
Tower Wire
Green
Green & Black
Tower Wire
Purple
Purple & Black
Crimp
Stbd Spk + Stbd Spk –
Port Starboard
Crimp
Port Spk + Port Spk –
If you have any questions please call : 1-321-638-1331
www.roswellmarine.com

Loop the safety lanyard over the tower next to the
speaker clamp.
BC
DE
FG
Apply RED Loctite to 3 bolts and fasten speaker
through tower speaker plate using a 5/16” allen key.
With your stereo/amp switched off, insert the Deutsch
wiring harness into speaker.
x6
TOWER
5/16”
Torque bolts
to 20 ft/lb
THREADLOCKER
Feed one end of the lanyard through the other end.
Insert the screw through the washer and lanyard loop. Using a Phillips head screwdriver, securely attach the
lanyard to the small hole on the speaker between the
base of the clamp and the Deutsch connector.. Do not
over tighten.
TOWER
TOWER
x2
Pg. 2/2
Rev. 28-May-15
Vamp Spin Speaker
Installation Instructions
If you have any questions please call : 1-321-638-1331
www.roswellmarine.com