Rowenta Ultra Professional Ultra Professional Steam... User manual

Ultra Professional
Instructions for Use

2
IMPORTANT SAFETY
INSTRUCTIONS
When using your iron, basic safety precautions should
always be followed, including the following:
Read all instructions before using the iron.
1. Use iron only for its intended use.
2. To protect against a risk of electric shock, do not
immerse the iron in water or other liquids.
3. The iron should always be turned to Minimum (Min)
before plugging or unplugging from outlet. Never
yank cord to disconnect from outlet, instead grasp
plug and pull to disconnect.
4. Do not allow cord to touch hot surfaces. Let iron
cool completely before putting away. Loop cord
loosely around iron when storing.
5. Always disconnect iron from electrical outlet when
filling iron with water, emptying iron or when not in
use.
6. Do not operate iron with a damaged cord or if the
iron has been dropped or damaged. To avoid the
risk of electric shock, do not disassemble the iron,
ship it to the nearest authorized Rowenta Appliance
Service Center for examination and repair. Incorrect
reassembly can cause a risk of electric shock when
the iron is used.
7. Close supervision is necessary for any appliance
being used by or near children. Do not leave iron
unattended while plugged in or on an ironing board.
8. Burns can occur from touching hot metal parts, hot
water or steam. Use caution when you turn a steam
iron upside down there may be hot water in the
reservoir.
9. The use of accessory attachments is not recommended
by Rowenta Appliance Company and may result in fire,
electric shock or personal injury.

3
SPECIAL INSTRUCTIONS
1. This is a 1440 watt appliance. To avoid a circuit
overload, do not operate another high wattage
appliance on the same circuit.
2. If an extension cord is absolutely necessary,
a 12-ampere cord should be used. Cords rated for
less amperage may overheat. Care should be taken
to arrange the cord so that it cannot be pulled or
tripped over.
3. Your Rowenta appliance is intended for household
use only.
SAVE THESE INSTRUCTIONS

4
■Description:
A Spray nozzle
B Covered water filling inlet
C Variable steam control
D Self clean system
E Spray button
F Burst of steam button
G Auto-off indicator light
H Temperature control dial
I Swiveling cord protector
J Supply cord
K Temperature light
L Long-Life System
M Precision Stainless Steel
Soleplate
N Transparent water tank
O Water level indicator
MNO
C/D
A
B
J
GH IEF
K
L

5
BEFORE USE
왎Please read the instructions for use and the Important Safeguards
carefully.
왎Remove the transparent soleplate protector.
왎It is normal for a small amount of smoke to be produced the first
time the iron is used. This will quickly disappear.
3-WAY AUTO-OFF
If the iron is not moved while it is plugged
in, an internal safety switch will turn it off.
It will turn off in 8 minutes if left vertically
or in 30 seconds if left on its soleplate or
tipped over. A red flashing light indicates
that the auto-off has been activated.
To switch the iron on again, move the iron
or gently shake it.
Wait until iron is fully reheated before
use.
STEAM IRONING
Filling with water
왎Ensure the iron is unplugged.
왎Slide the variable steam control comple-
tely to the left.
왎Open the water filling inlet cover.
왎Hold the appliance upright so that the
water inlet is horizontal. Fill with water
(containing no additives) to the max.
water level mark and close the lid.
Adding water
왎If you need to add water during ironing.
UNPLUG the iron and repeat above
steps.
왎Ensure iron is fully reheated after filling
(temperature indicator light goes out)
before ironing.
왎To avoid damage to clothes from dust
or dirt that may collect in the iron, we
recommend that for the first use or after
the iron has been stored for some time
that you first iron an old cloth, testing
both the steam and burst of steam
feature.
min
C
le
an
m
in
ma
x
S
el
f
30 sec.
8 min.
30 sec.