Rowenta BV 500944 User manual
-
,1-
1
ÜÜÜ°ÀÜiÌ>°V
Prelude COUL 20/06/06 12:21 Page a1
FIG
FIGFIG
FIG
FIG
FIG
FIG
FIG
Ó
£
Ó£
Ó
£
vv
vv
vv
vv
Prelude COUL 20/06/06 12:21 Page a2
5
Thank you for purchasing a Rowenta kettle. Carefully read these instructions, which apply to all our
models, and keep them ready to hand.
This product has been designed for domestic use only. Any commercial use, inappropriate use or
failure to comply with the instructions, the manufacturer accepts no responsibility and the guaranty
will not apply.
SAFETY INSTRUCTIONS
- Read the instructions for use carefully before
using your appliance for the first time and
retain them: Rowenta cannot be held liable if
the appliance is not used in accordance with
the instructions.
- Only use your kettle for heating drinking water.
- Always connect the appliance to an earthed
socket. Check that the supply voltage shown on
the rating plate of the appliance does, in fact,
match that of your electrical system.
- Never place the kettle or its base on a hot sur
face such as a hotplate or use it close to a
naked flame.
- Place on a flat, stable, heat-resistant surface.
- If anything appears to be wrong with its
operation, remove the mains plug from the
socket immediately.
- Do not pull on the mains cord to disconnect
the plug.
- Do not allow the mains cord to hang over the
edge of a table or worktop.
- Do not leave your hand or the mains cable in
contact with the hot parts of the appliance.
- Keep the appliance out of the reach of children.
- The use of this appliance by children or by
disabled persons must be supervised at all
times.
- Always take great care while the appliance is in
operation; be particularly careful of steam from
the spout, which is very hot.
- Note also that the body of stainless steel kettles
becomes very hot during operation. Do not
touch the kettle other than by the handle.
- If the supply cord or the plug is damaged, do
not use the appliance. To avoid any risk, the
supply cord should always be replaced by a
Rowenta approved service centre.
- Always refer to the instructions for de-scaling
the appliance.
- Our guarantee does not cover kettles that are
working badly or not at all through not being
de-scaled.
- Protect the appliance from humidity and frost.
- Do not use the appliance if it is not working
correctly or if it has been damaged. In such
cases you are advised to have the appliance
inspected by a Rowenta approved service
centre (see the list in the Rowenta Service
booklet).
- Except for cleaning and de-scaling, using the
procedures in the instructions for use of the
appliance, any work on the appliance must be
carried out by a Rowenta approved service
centre.
- Any supply connection error will nullify the
guarantee.
- Unplug the appliance and empty it if you stop
using it for an extended period and when you
clean it.
- All appliances undergo strict quality controls.
- Practical use tests are conducted with
appliances selected at random, which explains
any slight signs of use.
- Avoid using multiple outlet adapters or
extension cords. - In any event, take proper
account of the power consumption.
- Do not use the kettle when you have wet hands
or bare feet.
- Never move the kettle while it is in operation.
BEFORE USE
1. Remove all packaging, self-adhesive labels
and any accessories from inside and outside
the kettle.
2. Adjust the length of the mains cord by
winding it under the base. Squeeze the cord
into the notch. (fig 1)
GB
Prelude COUL 20/06/06 12:21 Page 5
6
1. To open the lid, depending on model:
- Lid with assisted opening: press on the latching
system and the lid will lift automatically (fig 2).
- Lid with automatic opening: press on the
button at the top of the handle (fig 3).
- Locking lid: turn the lid anti-clockwise to unlock
and lift off (fig 4).
To close, press firmly on the lid or, for the
locking lid, turn clockwise.
2. Place the base on a flat, stable, heat-resistant
clean and cool surface.
3. Fill the kettle with the desired quantity of
water (fig 5).
USING THE APPLIANCE
• Do not open the lid while the water is boiling.
Position the kettle and its supply cord well to
the rear of the work surface.
Do not place the kettle on or near slippery or
hot surfaces or allow the cord to hang above a
source of heat (cooking hob, gas cooker).
Your kettle must be used only with the base
belonging to it.
You can fill via the spout, which helps keep the
filter clear. Always fill with sufficient water to
cover the heating element (or the bottom of the
kettle).
Never fill the kettle while it is on its base.
The kettle must always be used with its own
ant-scale filter.
Do not fill above the maximum level or below
the minimum. If the kettle is overfilled, the
water may boil over.
Do not use without water.
Check that the lid is properly closed before use.
4. Place the kettle on its base. Plug into the
supply (fig 6).
5. To turn on the kettle, press on the on/off
button at the top or bottom of the handle,
depending on the model (fig 7).
6. Depending on the model, an indicator light
may come on.
7. The kettle will turn off automatically as soon
as the water comes to the boil. You can stop it
manually before lifting it off its base to pour.
Depending on the model, the indicator
light will go out when the kettle switches off
or is switched off. Ensure that the kettle is
switched off before lifting off its base.
On first use we recommend that you discard
the water as it may contain some dust. Rinse the
kettle and filter separately.
Connect the kettle only to an earthed socket.
If you need to use an extension cord, this must
have an earthed socket and be suitably rated.
Ensure that the cord and extension do not trail
to avoid any falls.
Do not leave water in the kettle after use.
.
Prelude COUL 20/06/06 12:21 Page 6
7
This filter neither treats nor removes the
hardness of the water. It thus conserves all the
qualities of the water. With very hard water, the
filter can clog very quickly (10 to 15 uses). It is
important to clean it regularly. If it is wet, put it
under a running tap, if dry, then brush it gently.
Sometimes the scale will not detach itself; it will
then need descaling.
CLEANING AND CARE
To clean your kettle
Unplug the kettle from the mains.
Allow it to cool and wipe with a damp sponge.
Never immerse the kettle, its base, the wire or
the electric plug in water: the electrical
connections and the switch must not be in
contact with water.
Do not use abrasive pads or cream cleaners. To remove the anti-scale filter, lift the kettle off
its base and allow to cool. Never remove the
filter when the appliance is full of hot water.
DESCALING
De-scale regularly, preferably at least once a
month or more frequently if your water is very
hard.
To de-scale your kettle:
• using white vinegar:
- fill the kettle with 1/2 l of vinegar,
- leave to stand for 1 hour without heating.
• using citric acid:
- boil 1/2 l of water,
- add 25 g of citric acid and leave to stand for
15 min.
• using a de-scaler specifically for plastic kettles:
follow the manufacturer’s instructions.
Empty your kettle and rinse 5 or 6 times.
Repeat if necessary.
To de-scale your filter
(according to model):
Soak the filter in white vinegar or diluted citric
acid.
Never use a de-scaling method other than that
recommended.
To clean the filter
(according to model) (fig 8)
The removable filter consists of a mesh to retain
the particles of scale and prevent them falling
into your cup when pouring.
Prelude COUL 20/06/06 12:21 Page 7
8
IN THE EVENT OF PROBLEMS
THERE IS NO EVIDENT DAMAGE TO YOUR
KETTLE
• The kettle does not work or stops
before coming to the boil
- Check that your kettle is properly connected.
- The kettle has been switched on without
water or an accumulation of scale has caused
the overheat cut-out to operate: allow the
ket tle to cool and fill it with water.
Descale first if scale has accumulated.
Switch it on: the kettle should start working
again after about 15 minutes.
• The water tastes of plastic:
Generally, this happens when the kettle is new,
discard the water from the first few boilings. If
the problem persists, fill the kettle to maximum
and add two teaspoons of bicarbonate of soda.
Bring to the boil and discard the water. Rinse out
the kettle.
IF YOUR KETTLE HAS BEEN DROPPED, IF IT
LEAKS OR IF THERE IS VISIBLE DAMAGE TO
THE POWER CORD, THE PLUG OR THE BASE OF
THE KETTLE
Return your kettle to your Rowenta After-Sales
Service Centre, only they are authorised to carry
out repairs. See the guarantee conditions and
list of centres in the booklet supplied with your
kettle. The type and serial number are shown on
the bottom of your kettle.
This guarantee covers manufacturing defects
and domestic use only. Any breakage or damage
resulting from failure to comply with the
instructions for use is not covered by the
guarantee.
Rowenta reserves the right to modify the
characteristics or components of its kettles at
any time in the interests of the consumer.
Do not use the kettle. No attempt must be
made to dismantle the kettle or its safety devi-
ces.
f the supply cord is damaged, it must be
replaced by the manufacturer, its after-sales
service centre or a similarly qualified person, in
order to avoid any danger.
PREVENTION OF DOMESTIC ACCIDENTS
For a child, a burn or scald, even if slight, can
sometimes be serious.
As they grow up, teach your children to beware
of hot liquids to be found in the kitchen. Position
the kettle and its supply cord well to the rear of
the work surface, out of the reach of children.
If an accident does occur, run cold water
over the scald immediately and call a doctor if
necessary.
In order to avoid any accident: do not carry
your child or baby at the same time as drinking
or carrying a hot drink.
ENVIRONMENTAL PROTECTION
Environment protection first !
Your appliance contains many recoverable or recyclable materials.
Take it to a local, civic waste collection point.
HELPLINE: If you have any product problems or queries, please contact our Customer Relations eam First for expert
help and advice:
0845 602 1454 - UK
(01) 461 0390 - Ireland
Or consult our website: www.rowenta.co.uk
Prelude COUL 20/06/06 12:21 Page 8
Table of contents
Other Rowenta Kettle manuals
