Royal Classics PLAZZO MARINA D1808-25 User manual

Assembly Instructions
MADE IN VIETNAM
Thank you for purchasing this quality product. Be sure to check all packing materials carefully for small parts,which
may have come loose inside the carton during shipment. Identify and count all items and compare with the PARTS
LIST and/or HARDWARE LIST shown below.
CAUTION: Please read the instructions thoroughly before assembly.
PAGE: 1OF2
1.We recommend that you assemble this product with the assistance of another person; this will make the
assembly easier, and will help eliminate damage to the product or injury to persons during assembly.
2.Please do not over tighten screws or bolts until the assembly is completed.
3.Please put all parts on a non-abrasive floor before assembly, and follow the assembly steps to assemble
your newly purchased product correctly and efficiently.
PARTS LIST
NO: COMPONENT SKETCH Q'TY
A
B
2PCS
C4PCS
HARDWARE LIST
NO: COMPONENT SKETCH Q'TY
1
2
3
4
5
LEG
CHAIR BACK
SEAT
D1808-25: PLAZZO MARINA ARM CHAIR (2/CTN)
DRIGHT SIDE
FACING ARM
E
6
7
8PCS
Bolt 1/4"x1-1/2''L
8
9
16PCS
2PCS
Lock washer Ø1/4"
Flat washer Ø1/4"
Lock washer Ø5/16"
Flat washer Ø5/16"
Allen Key 1/6''
Screw #4x2''L
18PCS
18PCS
8PCS
8PCS
1PC
4PCS
2PCS
2PCS
2PCS
Bolt 5/16"x2-3/4''L
Center Bolt 5/16"x1-3/4''L
LEFT SIDE
FACING ARM

STEP 1 STEP 2
MADE IN VIETNAM PAGE: 2OF2
Assembly Instructions
B
C
A
1
8
4
5
24
5
8
B
C
815
4
Place the chair back (A) on a soft and clean surface
and assemble the seat (B) with the chair back(A) by
using Allen Key (8) with hardware 2,4, and 5. Then
assemble the seat (B) with the back legs of the the
chair back (A) using Allen Key (8) with hardware 1, 4,
and 5.*Attention: DO NOT TIGHTEN THE BOLS.
Assemble the front legs (C) with the seat (B) by using
Allen Key (8) with hardware 1,4, and 5.
*Attention: DO NOT TIGHTEN THE BOLTS.
D1808-25: PLAZZO MARINA ARM CHAIR (2/CTN)
STEP 3
B
9
37
6
8
D
E
Assemble the Left side facing Arm (E) with the seat
frame (B) by using Allen Key (8) with hardware 3,6
and 7. Then assemble the Left side facing Arm (E)
with the chair back (A) by using hardware 9.
Repeat the step to assemble the Right side facing
Arm (D).
STEP 4
To level the chair, stand the chair up on a flat surface
and tighten all the bolts and screws.
*Please use center bolt