ROYOLE RoKit User manual

Royole RoKit User Manual
1. User Guidance
1.1 Development model
1.1.1 Connection method
1.1.2 Connection method of expansion accessories
1.2 Flexible display mode
2. Precautions
3. Technical Support
1. User Guidance
1.1 Development model
By connecting the fully flexible display (FFD) and the development
motherboard to build a basic development kit, users can use the basic
development kit to carry out creative development such as building
applications or flexible interactions, with sensors included in the system for
developers to use.
1.1.1 Connection method

• Connect the components as shown.
• Press and hold for 3 seconds [Power on/off button] to enter boot.
• Type-C connected to the computer for development and
debugging
• Please use a matching adapter for power supply (not included), or
through the power bank (5V2.0A).
• To enhance Wi-Fi signal reception, please connect a Wi-Fi antenna.
1.1.2 Connection method of expansion accessories
Expansion
Accessories
Connection Method
FFD extension cable
FFS lead board
FFS lead board pin definition

FFS expansion board
Microphone
expansion board
Optical distance
sensing expansion
board

1.2 Flexible display mode
Assemble the flexible display by connecting the FFD and HDMI adapter
board, the signal is then provided through the HDMI connection.
• Connect the components as shown.
• The output resolution of the host must be set as 1440*1920.
Power conversion
board
Wi-Fi antenna

2. Precautions
Structural FFD Lamination Structural FFS Lamination
The thickness of the complete flexible display is only about 0.01 mm (10
micrometers).
In order to adapt to the daily use scenarios of developers, the thickening
protection treatment is carried out.
Please abide by the following guidance for daily operation of the FF and FFS:
1. Unless you are a professional, do not tear or disassemble any laminated
or protective films of the fully flexible display or fully flexible sensor
which could result in ineffectiveness.
2. Please use your fingers only for touch operation to avoid any violent
touch of sharp objects or other objects.
3. Please use even force to fold the fully flexible display and fully flexible
sensor.
• FFD bending zone
DO NOT bend the line interface area, otherwise it will cause damage to the

line/device and cause malfunction.
• FFD outer/inner bending minimum bending radius
The thickness of the Royole flexible display is only about 0.01 mm, and the
bending radius can reach 1 mm. Taking into account the actual use of the
development and application, the corresponding cover and laminate have
been added to the original flexible display. Therefore, the bending radius of
the fully flexible display in the flexible development kit is 15 mm to meet the
needs of different usage scenarios.
If you have a customized requirement for a fully flexible display, you can send
an email to [e-mail]

• FFD bending ways and area

3. Technical Support
For more development guides and technical support, please visit our
official website address:
https://global.royole.com/us/developer-rokit
Thank you for your support!
Wishing your flexible ideas can become reality in your hands!
Legal Disclaimer
©2021 Royole Corporation. The Royole logo, and Royole are registered
trademarks of Royole Corporation. All rights reserved.