RP3 Rowing S User manual
Instructions for using linking bars
Linking bars can be used to connect either the machine body (effectively the feet), or the
handles of RP3 Model S rowing machines together. This enables crew memebers to feel
what each other are doing and synchronise their movements and timing on the drive and
recovery of the stroke.
Connecting the feet
To connect the feet, use the cross-link bars (Fig1.) and clip them on to the mounts attached
to the body of the machine (see below). Ensure the machines are parallel and the right
distance apart to make this easier. They are unclipped by pulling back the metal tab and
lifting them off.
Fig1. Cross Link Bar
Fig2. Handle Link Bar
IMPORTANT: After connecting the machines together, unlatch them both from their bars
and slide them all the way to each end of the bar with no one sat on the machines to ensure
they are parallel to avoid damaging your machines when they are used.
Connecting the Handles
To connect the handles, use the handle link bar (Fig2.) and the clips which clip onto the
handle-chain connector as pictured below. Then, ensuring the RP3s are the right distance
apart, simply slot the handle link over the clips.
Exclusive distributor for the UK and Ireland
Email:
Phone: +44 (0)7756 136600
www.rp3rowing.co.uk
Table of contents
Other RP3 Rowing Home Gym manuals
