RTS Zeus II User manual

Zeus II
Trunking Digital Matrix Intercom System
You need the capabilities, redundancy and programmability of a full-featured, top of the line digital matrix intercom system, but
have limited space in which to add the equipment. You also need to be able to expand the intercom system as your communica-
tions needs grow.
The RTS Zeus II matrix intercom system provides 24 channels of high-quality audio in a compact 2 rack unit package with the
added benet of linking to other RTS matrix intercoms via intelligent trunking.
Each channel is capable of supporting any of the RTS line of matrix keypanels, or four-wire inputs and outputs for program, party
line and IFB feeds.
The Zeus II comes complete with AZedit, a Windows based, full-featured conguration software, providing on-line and off-line
programming capabilities.
Redundant power supplies standard
The unit comes complete with two completely independent
power supplies that can be powered from separate AC
feeds. Because of the extremely low power consumption, the
use of low cost UPS units for particularly critical installations
is possible.
Meet any communications needs without rewiring, jump-
er changes, or the need to take the system “off-line”
Nearly all changes can be made by the users, using a
keypanel. More involved changes can be made on-line or
off-line using the Zeus-Edit programming software.
Better than CD quality audio
Zeus uses the RTS TDM ASIC to perform all audio switching
and mixing in the digital reel. Input and outputs are convert-
ed at 44.1 kHz, 20-bits for a full 20 kHz bandwidth. The TDM
ASIC performs all DSP with 45-bits resolution, avoiding any
degradation of communications, regardless of the number of
users on a given path.
All communications modes are provided
Zeus comes standard with full support for point-to-point
communications, party-line conferences, IFBs, Isolate, and
special lists.
External interfaces standard
Eight general purpose inputs and outputs (GPIOs) are
provided for control of external devices including two-way
radios, VOXs, tally and alarm indicators. A serial port is also
provided for connection of RTS accessories including ad-
ditional GPIO, level control panels, conference assignment
panels and program assignment panels.
Features
Line Drawing

Zeus II Specications
Matrix
Size: 24 Ports
Processing: Digital, 45 bits
Conversion: 44.1 kHz, 20 bits
Programming: Zeus-Edit via Windows
Memory: Non-volatile Flash
Controls and Indicators
Power On / Off toggle switch, located on back panel
Reset pushbutton switch, recessed in front panel
Diagnostic pushbutton switches (2), recessed in front
panel
Power On indicator
General Status Indicator
Keypanel Status indicators (24)
Zeus controller status indicator
Zeus audio status indicator
Zeusedit status indicator
UIO-256 status indicator
LCP-102 status indicator
Miscellaneous diagnostic indicators (19, for service only)
Note: all indicators located on front panel
Audio Performance
Input Type/Impedance: Active Balanced, 22kΩ
Output Type/Impedance: Active Balanced, 600Ω
Operating Level: +8 dBu
Maximum Level: +20 dBu
Freq. Response at +20 dBu: 50 Hz to 20 kHz, ± 1dB
THD+N at +20 dBu (unweighted): <0.007%
SNR at +20 dBu (A-weighted): >90 dB
Crosstalk at +20 dBu: <-80 dB
CMRR: >85 dB
Connections
Intercom Channels (J1 to J24)
General: 4-wire, balanced audio; RS-485 data for
optional intelligent keypanels
Connector type: 9-pin male D-sub (DE-9P)
Pin 1: Keypanel data +; Pin 2: Keypanel data -; Pin
3: Audio out shield; Pin 4: Audio in + (high); Pin 5:
Audio in - (low); Pin 6: Keypanel data shield; Pin 7:
Audio out - (low); Pin 8: Audio out + (high); Pin 9:
Audio in shield
Conguration Computer (J25)
General: RS-232 Serial port
Connector type: 9-pin female D-sub (DE-9S)
Pin 2: RX; Pin 3: TX; Pin 5: Ground
Accessory Connector (J26)
General: An RS-485 data port for LCP-102 / PAP /
UIO-256 connection.
Connector type: 9-pin female D-sub (DE-9S)
Pin 1: LCP-102 / PAP / UIO-256 RS-485 data -; Pin
2: ground; Pin 3: N/C; Pin 4: N/C; Pin 5: N/C; Pin
6: LCP-102 / PAP / UIO-256 RS-485 data +; Pin 7:
ground; Pin 8: N/C; Pin 9: N/C
GPI (General Purpose Interface) Connector (J27)
General: Provides 8 control inputs which can simulate
keypanel keys, and 8 control outputs which can be as-
signed to keys and used to activate external devices.
Connector type: 25-pin female D-sub
Ports
Keypanel: DB-9M
Audio IN
Audio OUT
RS-485 Data
Conguration: DB-9F
RS-232 Data
Accessory Port: DB-9F
RS-422 Data
Trunking Port: DB-9M
RS-232 Data
GPIO: DB-25F
TTL Active Low
Physical/Power
Power Requirements: 90-250 VAC, 50/60 Hz, 60W
Note: Primary and backup supplies are identical.
Size: 3.5” H x 19” W x 17 D” (88.9mm H x 482.6mm W x
431.8 D)
Weight: 10.68 lbs (4.84 kg)
Ordering Information
Zeus II
Trunking Capable Digital Matrix Intercom System
Catalog Number: 90007731000
This specications information is preliminary and is subject to change without notication.
Brand names mentioned are the property of their respective companies.
Contact Information
Telex Communications, Inc.
12000 Portland Avenue South
Burnsville, Minnesota 55337
Telephone: 877·863·4169
Fax: 800·955·6831
Form Number: LIT000034000
Date: April, 2006