RUKO Carle Instruction Manual
Disclaimer & Safety Guidelines
3+
for age
2021.08
v2.0
1 Safety at a Glance
Please read this Disclaimer & Warning and Safety Guidelines carefully before using our
product.
This product is not recommended for people under the age of 3.
You agree to use this product only for purpose that are proper and in accordance with local
regulations, terms and all applicable polices and guidelines Ruko may make available.
When using this product, please be sure to strictly abide by the specification requirements
and safety guidelines sated in this document.
Any personal injury property damage, legal disputes and all other adverse events caused
by the violation of the safety instructions or due to any other factor, WILL NOT be Ruko's
responsibility.
Suitable for users aged 3 and above.
Keep the product away from fire and heat. In addition, please keep it dry and clean.
Please take good care of the product. Don' t apply too much force while holding it.
Please use the robot on a flat surface.
While the robot is operating, please don't hold its joints to avoid pinching your fingers and
damaging the robot.
Please use the provided original charging cable to recharge the robot. (Charger not included)
Please don't disassemble the robot's joints on your own.
If you need to disassemble or repair the robot , please contact our after-sales service team.
By using this product, you hereby agree to this disclaimer and signify that you have read
it fully. You agree that you are responsible for your own conduct and damaged caused
while using this product, and its consequences.
The following terms are used throughout the product literature to indicate various
levels of potential harm when operating this product:
1.1 Glossary
1.2 DISCLAIMER AND WARNING
1.3 ATTENTION
Recommend Warning Hints & Tips
!
If the robot behaves abnormally, please cut off the power to avoid finger-pinching and
robot damage.
Copyright ©2021 Ruko All Rights Reserved. 1
While operating the robot, please don't put it at an elevated position or a place close to
edges to avoid the risks of falling down and damage.
The company cannot be held liable for any damage resulting from inappropriate use.
With updated versions, the built-in apps of the robotand the pictures of the apps might
vary. This manual contains important information. Please keep it for future reference.
Please cut the power o, stop using the robot, and contact our after-sales
service team under the following circumstances :
The robot is emitting smoke or scorched smell.
Water or other foreign matters get inside the robot.
The robot is damaged.
!
Copyright ©2021 Ruko All Rights Reserved.2
2 Battery Guidelines
It is prohibited to use computer USB, simple USB, and inferior charging cables for charging.
It is forbidden to overcharge the battery, please remove charging cable in time after fully charged
to avoid damage due to overcharge.
USB Adapter
（5V 2A）
Inferior charging cables
USB Adapter
（>5V 2A）
Copyright ©2021 Ruko All Rights Reserved. 3
Original charging cable
USB Adapter
（5V 2A）
3 Daily Maintenance
Do not allow Robot and Transmitter to touch with any kind of liquid, or put it under sun
exposure, severely squeezed, and dropped from high altitude.
Detach the USB charger when the battery is fully charged.
Fully charge the battery at least once every month to maintain battery health.
DO NOT disassemble or pierce a battery in any way or it may leak, catch fire, or explode.
DO NOT touch the electrolytes in damaged batteries, it may injure your skin or eyes.
Discharge the Robot Batteries to 50% or lower during transport.
Fully charge the battery before using it for the first time.
Liquid Sun Exposure Severely Squeezed
Do not put the battery in the Transmitter when
not in use. Because battery will discharge, power
will slowly decrease.
Please play with the robot on a flat and smooth ground, do not play with robots on high
places, uneven, sand, grass, beds, sofas etc.
Violent strike or trampling is strictly prohibited.
Repeated strike or trampling may cause damage
to the robot and oil paint may fall off.
4 Environment Guidelines
Copyright ©2021 Ruko All Rights Reserved.
4
Please make sure that the power of the robot is turned on before playing.
Turn on the robot, then turn on the remote controller, please pair it with robot.
Connect robot Bluetooth with your phone, make sure that the App in the phone is connected
to the Bluetooth named "JT_xxxx". (Reference to the Bluetooth Guidelines)
5 Preparation Before Play
6 Bluetooth Guidelines
Open the Bluetooth settings and connect your phone to the advice, "JT_Speaker". The robot will
then function as a Bluetooth speaker.
Open Carle APP, connection with robot Bluetooth "JT_xxxx",please wait for about 2-10 seconds,
then can control the Carle robot through App.
If you still without connect to Bluetooth, please check whether the Bluetooth of your phone.
Copyright ©2021 Ruko All Rights Reserved. 5
7.1 Transmitter cannot control the robot
7 Problems You May Encounter
7.2 Voice can not be recognized
7.3 Can not connect to APP
Bluetooth is not turned on, APP is Bluetooth connection, *not WiFi.
Whether it is connected to the wrong Bluetooth, one is a Bluetooth Playback（named
“JT_Speaker”）and the other is a Bluetooth APP（named “JT_xxxx”）control .
Need to wake up and connect app again.
Check if the remote control has power.
Need to aim at the robot head to control.
Only be controlled at a distance of 3-5 meters without any obstructions.
Please avoid use the product under the strong light (such as spotlight and strong sunlight)
to cause loss radio signal control. If you have to use robot under the strong light, please
connect Carle to the App on your phone.
Voice commands that did not follow the instructions.
Voice pronunciation is not standard or speaking speed is too fast.
The robot is running (need to stop to recognize voice commands).
Noisy environment.
Copyright ©2021 Ruko All Rights Reserved.6
If you have any questions about this product, please contact Ruko by sending a message to
www .rukotoy.com
Other manuals for Carle
3
Table of contents
Other RUKO Robotics manuals
