Rumidimur RecoveRay Sport User manual
InstructIons For use
3
1. Component legend
2. Battery charging
Insert the batteries (type AAA) into the battery compartment. Plug
the charger into an electrical outlet and connect the charger to
the socket. Battery charge time is approximately 7 hours, or until
the word “FULL” appears on the screen. It is recommended to charge the device once every three days, overnight.
3. Battery warnings
• The AC/DC charger that comes with the device is the only charger allowed for use.
• Do not take apart the batteries, heat them over 100°C or burn them.
• Discard the batteries at an appropriate recycling center.
• Do not turn the device on while it is being charged.
• Do not, under any circumstances, charge ordinary, non-rechargeable batteries; it might cause a fire.
Content:
1. Component legend
2. Battery charging
3. Battery warnings
4. Safety precautions
5. Contra indications
6. Operating instructions
7. Treatment protocol
8. Control panel and troubleshooting
9. Technical specifications
10. Device maintenance
11. Warranty
5. Pressure switch area
4. Treatment start push-button
3. LCD display, Timer
2. Treatment time setting button
6. Battery compartment cover
1. Main power switch
7. Charger socket
Package content:
• RecoveRay device
• RecoveRay case
• Instructions For Use
• Batteries
• Charger
• Adaptors
Upon opening the package, please
verify that it contains all the above
mentioned equipment. Please
make sure the device is unharmed.
If anything is missing or damaged,
please contact the distributor
immediately after purchasing.
54
4. Safety precautions
•Neveraimthelaserbeamattheeyes.
•Itisalwaysrecommendedtoconsultyourdoctororaprofessional.
•Ifyouarepregnantdonotusethedevicetotreatthestomach.
•Donottreatanareawithamalignanttumor.
5. Contraindications
None
6. Operating instructions
6.1 Switch the device ON
Pressthemainpowerswitch(No.1).Afterashortbeepthedisplaywillswitchonandatimerwillbedisplayed(No.3).
6.2 Set treatment time
Pressthetreatmenttimesettingbutton(No.2):onitsrightsidetoincreasetime(+)oritsleftsidetodecrease
time (-). The timer is adjustable in increments of 30 seconds.
6.3 Operate the laser beam and begin treatment
Pressthetreatmentstartpush-button(No.4),usingonehand,andverifythatthegreenlightison.Keepit
pressedandsimultaneouslypressthemainpowerswitch(No.1).Nowreleasebothbuttonsatthesametime.
Thelaserbeamisoperatedandtreatmentcanbegin.Placethedevicegentlyuponyourskin.Note-Ifyou
pressthepressure-switcharea(No.5)toohardupontheskin,theactionwillpause.Tostoptheoperation,
brieypressthetreatmentstartpush-button(No.4)orthepressureswitch(No.5).
Anothermethodofuseisbypressure.Afterhavingsettreatmenttime,placethepressure-switcharea(No.
5) on the treated area, and gently press the device on your skin. This will automatically activate an electronic
micro-switch and start the laser device. To stop the device, lift it away from your skin.
During operation, you will notice a green light indicating that the device is on. Beeps sounding at 3-second
intervalswilldenotetimer’scountdownuntilreaching“00:00”,thenitwillstopautomaticallyandsoundabeep.
Hold the device steadily and motionlessly on the skin for the whole duration of the treatment.
6.4 End of treatment, reset and turn OFF
To switch o the device, press the main power switch until a beep sounds. Release the button and the
display will go blank. If the planned treatment time has not been fully utilized, the timer will display the
remaining time at startup.
To reset the timer, switch o the device, then press the main power switch for longer than 2 seconds while
switching on the device.
7. Treatment protocol
7.1 Intended use
RecoveRay Sport is intended for the management of pain including: Chronic back
pain; Chronic neck pain; Knee pain; Carpal Tunnel Syndrome (CTS); Fibromyalgia;
Myofascial Pain Syndrome (MPS); Temporomandibular Joint Disorder; May help as an
adjunctive treatment for acute and chronic wounds.
7.2 Treatment course and dosage
Start treatment in 1.5 minute dosage for each treatment point and increase the
dosage by 30 seconds every day, until reaching 6-8 minutes per treatment
point, per treatment. Treat 2-4 times a day, consistently. If you experience
increased pain following treatment, stop the treatment for 24 hours then
start again with a reduced dosage. If there is no increase in pain level,
increase the dosage gradually, until reaching 6-8 minutes per treatment point,
2-4 times a day.
7.3 Coverage
The laser beam size is 4.5 cm long and 1 cm wide. If the area that requires treatment is
larger than the 4.5/1 cm, repeat treatments on the adjacent area until you’ve covered the
whole area.
7.4 Treatment recommendations for common conditions
The recommended time for each point of treatment is 6-8 minutes, 2-4 times a day.
1. Chronic back pain - Treat lengthwise along the painful vertebrae of the lower back, to the left and the
right of the spine. For Ischia - pain radiating to the lower limb - Identify the focal point of the pain by
touch and treat it.
2. Chronic neck pain - Treat a) Lengthwise, along the vertebra. b) Treat each side of the neck, lengthwise;
under the ear lobe, and exactly at the indentation behind the jaw.
3. Knee pain - Treat the sore knee a) On the back of the knee along the inner crease. b) On the outer side
of the knee, lengthwise. c) On the inner side of the knee, lengthwise. You can also treat the front of the
knee, under the kneecap.
4. Carpal tunnel syndrome (CTS) - Treat the sore wrist a) On the inside, along the width of the joint - on
the crease. b) On the inside, perpendicular to ‘a’, lengthwise. c) Treat the length of the thumb, along the
pad. You can also treat the back of the hand, at the gap between the thumb and the bone of the index
finger towards the joint, and from both sides of the joint, lengthwise.
5. Fibromyalgia - Treat the aching area.
1 cm
4.5 cm
The size of the laser
beam of the
RecoveRay
76
6. Myofascial pain syndrome (MPS) - Treat the aching area.
7. Temporomandibular Joint Disorder - Treat along the length and width of the TemporoMandibular joint.
8. Adjunctive treatment for acute and chronic wounds - Treat over the entire wound area.
Tip: Always start from the most painful point and then move to other spots, so as to ensure you are treating
the central problem first, to the best of your knowledge.
Back viewFront view
Human body illustration with recommended treatment points:
•Notetheillustratedbeamdirection
•You may treat any point on the body except the eyes
8. Control panel and troubleshooting
Display Status
Batteries charging
Batteries fully charged
The icon- is displayed to indicate the device is currently operating
Full battery power
Low battery power, two beeps will sound after startup as a reminder to recharge. Charge the
batteries
Nobatterypowerremains.Chargethebatteriesimmediately
The device will shut down automatically after 10 beeps due to lack of battery power. Charge the
batteries
Batteries are not charging. Switch the device off then on again to fix this error.
If the problem persists, switch off the device, remove the batteries and then reinsert them.
If the problem persists, ship or deliver personally the device to the service center.
The indication "LOW" is displayed when laser power level is below the required level.
Treatmentshouldbestopped.Causemaybeoneofthefollowing:
1. Battery power is too low.
2. Diode lifespan has reached its end and should be changed at the service center.
3. The device is operated in a different environment than for which it was designed, e.g.
temperatures higher than 40°C. Charge the batteries, switch on the device and see if the
writing "LOW" has disappeared. If not, verify that room temperature is not exceptionally high, and
if necessary move away from the hot area. If not higher than 40°C and the writing "LOW" is still
displayed - ship the device to the service center for diode change.
Additionalsignalsforerrorsofthistype:
Hardware/software error has occurred. Switch the device off, then on again, to fix this error.
If the problem persists, switch off the device, remove the batteries and then reinsert them.
If the problem persists, ship or deliver personally the device to the service center.
Neck Scin injuries
Tennis elbow
Thigh
MCL medial
colateral ligament
Heel spur
Wrist
Gol elbow
LCL external
lateral ligament
Patellar tendon
Shin
Sprained ankle
ligament
Toe joints
Trigger
points
Upper back
Lower back
Sciatica
Finger
joints
Hip
Knees
Achilles
tendom
Shoulder
98
9. Technical specifications
Property Units Description, value Notes
Laser type GaAIAs Solid state laser diode
Maximum power mW 250 Max
Wave length (infrared) nM 808
Pulse frequency kHz 14
Laser pulse duration μs 22
Diode lifespan hours Over 3000
Energy per minute Joul 4.5
Laser beam dimensions (LXH) mm Length 45 x width 10 at opening
Beam divergence degrees ±3
Green control light indicator nM 520 Green light beam signaling device is operating
Timer setting minutes 00:00to99:30
Timer intervals seconds 30 Increment or decrement
LCD display dimensions mm 26 x 15 Visible area
Timer display 4digits(88:88) 1-second intervals
Beep warning yes Display:Deviceon,off,operating,
low laser power, errors
Power supply W3.2 maximum
Automatic shutdown 2 options
automatic shutdown when not in use for
10 minutes; 5 minutes when timer is set to 0
(00:00)
Battery 3AAArechargeablebatteries(NiMH)
Batteries lifespan hours over 2 with fully charged batteries
Battery charging time hours 5-7 with discharged batteries
Batteries charging current mA 300 minimum
Power supply VAC 100 to 240 AC/DC charging adapter 115/230 VAC, 65/50
Hz Supply 9 V, 500 mA
Property Units Description, value Notes
Dimensions mm 200 x 70 x 40
Charger output voltage
VDC
9
Weight grams 175
Operating conditions
C°, %
temp. 0
°
to 40
°
,
humidity 15% to 90% without condensation
Storage conditions
C°, %
temp. -20
°
to 55
°
,
humidity 10% to 95% without condensation
10. Device maintenance
1. Cleanthepressureswitcharea,No.5,usinga70%alcoholsolution.Cleanbetweensessionsifneededandbefore
handing it to another person’s usage.
2. Be sure to keep the pressure switch area down while cleaning, to prevent wetting the lens.
3. Keepthedeviceinproperstorageandworkconditionsasspeciedinthetechnicalspecicationtable,donot
leave the device in the car in hot weather.
11. Warranty
The warranty is for 12 months according to company policy, as is detailed on warranty certificate. If batteries
and/or a charger are supplied with the device, they are not included in the warranty. The manufacturer/
distributor is responsible for performance, safety and reliability of the equipment only on condition that all
repairs are carried out exclusively by Company - authorized personnel.
Consult accompanying documents Temperature limitation Humidity limitation
Electrical and electronic equipment
CE marking of conformity Caution, consult
accompanying documents
Type BF IP22 – International Protection Manufacturer
Recycling Authorized representative in the European community
3 x 1.2V AAA Rechargeable batteries | 9V, 300 mA (For charging via AC/ DC adaptor)
10
Manufactured for Rumidimur DMCC
AG 28C, AG Tower, JLT, Dubai, United Arab Emirates
Tel:+97145136460,support@rumidimur.com,www.rumidimur.com
Manufacturer: Biocare Enterprise LTD
Rm 1301, 13/F, Chinachem Tsuen Wan Plaza,
457CastlePeakRoad,TsuenWan,N.T.HongKong
Made in China
Authorized Representative: Obelis SA
Bd General Wahis 53 1030 Brussels, Belgium
Tel:+(32)2-732-60-03Fax:+(32)2-732-59-54,
mail@obelis.net,www.obelis.net
