DAYSHIFT
Panel
To set up an automated recording enter the
three required times using the keyboard
and/or the number pad on your keyboard.
Clicking in the Rec Start field highlights the
whole field, so you’re ready for time entry. You
do not need to type any leading zeroes or
symbols, so for example, to start at 1AM all
you need to type is 10000.
: For all time entries the system requires
24 hour (military) time. HHMMSS
There is no need to use the tab key or click on
each box individually to move from field to field.
Clicking the <enter> key after typing the
desired value will take you to the next field.
Example:
To start a recording at 5:00pm, record for one hour, and start playing back at 5:30pm, follow these
steps … as illustrated in the graphic above:
1) Enter an appropriate name for your recording in the File Name box.
2) Check the Daily box if you wish the system to repeat the scheduled record every day.
Note: The amount of Disk Space Available for storing your recordings is displayed in the upper
right of the DayShift panel.
3) Click on the Rec Start box – type 170000– and click <enter>
4) In the already highlighted Duration box – type 10000 – and click <enter>
5) In the already highlighted Play Start box – type 173000 – and click <enter>
Beneath the time entries you’ll see status messages as you enter times, as well as system status
regarding the current state of automated recording and playback.
The DAYSHIFT
panel can also be used to record in manualmode.Just click the RECORD button to
start recording, and then manually start playback of the file from the File Browser panel. Here is
how it works:
To set up a manual recording …
1) Enter an appropriate name for your recording in the File Name box.
2) When you’re ready to start recording, click the large RECORD button.
3) Once the recording starts, you’ll see the File Name appear in the File Browser.
Click once at any time to select and cue the file in the Preview Monitor, even
while it’s recording. You can use the Preview Monitor to set any desired start
point for manual playback.
4) Click the TAKE or AUTO (fade) button, or press <enter> to begin playback of the file to the system
output. DAYSHIFT User Guide Page 5
