Russell Hobbs RHI802 Installation guide

INSTRUCTIONS AND WARRANTY
MODEL NO. RHI802
RUSSELL HOBBS STEAM IRON

2
Congratulations on purchasing our Russell Hobbs Steam Iron. Each unit is
manufactured to ensure safety and reliability. Before using this appliance for the first
time, please read the instruction manual carefully and keep it for future reference.
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be followed
including the following:
1. Please read the instructions carefully before using any appliance.
2. Always ensure that the voltage on the rating label corresponds to the mains
voltage in your home.
3. Incorrect operation and improper use can damage the appliance and cause injury
to the user.
4. The appliance is intended for household use only. Commercial use invalids the
warranty and the supplier can not be held responsible for injury or damage
caused when using the appliance for any other purpose than that intended.
5. Avoid any contact with moving parts.
6. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
7. Children should be supervised to ensure that they do not play with the appliance.
8. Check the power cord and plug regularly for any damage. If the cord or the plug
is damaged, it must be replaced by the manufacturer or a qualified person in
order to avoid an electrical hazard.
9. Do not use the appliance if it has been dropped or damaged in any way. In case
of damage, take the unit in for examination and/or repair by an authorised service
agent
10. To reduce the risk of electric shock, do not immerse or expose the motor
assembly, plug or the power cord to water or any other liquid.
11. Never immerse the unit in water or any other liquid for cleaning purposes.
12. Remove the plug from the socket by gripping the plug. Do not pull on the cord to
disconnect the appliance from the mains. Always unplug the unit when not in
use, before cleaning or when adding or removing parts.

3
13. The use of accessory attachments that are not recommended or supplied by the
manufacturer may result in injuries, fire or electric shock.
14. A short cord is provided to reduce the hazards resulting from becoming
entangled in or tripping over a longer cord.
15. Do not let the cord hang over the edge of a table or counter. Ensure that the cord
is not in a position where it can be pulled on inadvertently.
16. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas
or electric burner or in a heated oven.
17. Do not use the appliance on a gas or electric cooking top or over or near an open
flame.
18. Use of an extension cord with this appliance is not recommended. However, if it
is necessary to use an extension lead, ensure that the lead is suited to the power
consumption of the appliance to avoid overheating of the extension cord,
appliance or plug point. Do not place the extension cord in a position where it can
be pulled on by children or animals or tripped over.
19. This appliance is not suitable for outdoor use. Do not use this appliance for
anything other than its intended use.
20. DO NOT carry the appliance by the power cord.
21. Do not leave this appliance unattended during use. Always unplug the unit when
not in use or before cleaning.
22. Always operate the appliance on a smooth, even, stable surface. Do not place
the unit on a hot surface.
23. Ensure that the switch is in the “Off” position after each use.
24. The manufacturer does not accept responsibility for any damage or injury caused
by improper or incorrect use, or for repairs carried out by unauthorised
personnel.
25. In case of technical problems, switch off the machine and do not attempt to repair
it yourself. Return the appliance to an authorised service facility for examination,
adjustment or repair. Always insist on the use of original spare parts. Failure to
comply with the above mentioned pre-cautions and instructions, could affect the
safe operation of this machine.

4
PARTS DIAGRAM
OPERATING INSTRUCTIONS
It is normal for a small amount of smoke to be seen the first time the iron is used,
this will quickly disappear.
When using the steam function for the first time, do not direct the steam towards
the laundry, as there could be debris from the steam vents.

5
FILLING WITH WATER
We recommend the use of distilled or kettle water.
Make sure that both the Steam Control turning Knob and Temperature Control
Dial are in the “OFF” position.
Hold the iron upright so that the water-filling inlet is in a horizontal position.
Fill with water through Water Filling Inlet until the water reaches the “MAX” mark
indicated on the side of the iron, and never fill above this mark.
SETTING TEMPERATURE
Follow the ironing instructions on the garment label. If there is no instruction but you do
know the kind of fabric, please consult the following table.
Note: If the fabric consists of various kinds of fabrics, always select the temperature
required by the most delicate fabrics.
Fabric
Temperature control
Temperature requirement
Synthetic
●
Low temperature
Silk, wool
●●
Medium temperature
Cotton, linen
●●●
High temperature
STEAM IRONING
Place the iron in a vertical position and set the temperature control dial to the
minimum/lowest heat setting.
Insert the plug into the socket, and then turn the temperature control dial to the
“high heat” marking. The pilot light will come on, indicating that the iron is heating
up.
When the pilot light turns off, the set temperature has been reached and the iron
is ready to use.
During ironing, the pilot light on the iron automatically switches on/off as the
thermostat maintains the set temperature (you may continue ironing during this
process).
Turn the steam control turning knob to the required position.
Steam is produced as soon as the iron is held horizontally.

6
SPRAYING
Press the spray button to spray water on clothes, as often as required.
Please Note: When using the water spray function, ensure that there is enough water in
the water tank, and you may have to pump the spray button several times at first in order
to start the spraying function.
BURST OR VERTICAL STEAM IRONING
Press the burst of Steam button to generate a powerful burst of steam that can
penetrate the fabrics and smooth the most difficult and tough creases. Wait for a
few seconds before pressing again.
By pressing the Burst of Steam Button you can also iron vertically (e.g. curtains)
Please Note: The burst steam function can only be used at high temperature. Stop the
emission when the pilot light turns on, and then start ironing again only after the pilot
light has turned off.
DRY IRONING
For ironing without steam, follow the instruction in section “steam ironing”, however, the
steam control turning knob should remain in position “O” (no steam).
FABRIC & TEMPERATURE INDICATOR
Use the Electronic Temperature Control to select the desired fabric setting. The lights in
the water tank will light up, at the same time lights will start to flash; they will stop
flashing when the iron reaches the selected temperature.
CLEANING AND MAINTENANCE
This appliance is for household use only and is not user-serviceable.
Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.
Always remember to unplug the unit from the electrical outlet when not in use
and before cleaning. Ensure that the speed control is set to “0”.
It is much easier to clean the accessories directly after they have been used.
Wash them in warm, soapy water, rinse and dry well.

7
The body of the appliance and the stand should be cleaned with a damp cloth.
Do not let water enter the appliance or the stand.
Do not use bleach or other abrasive substance or solvents to clean your
appliance as it can be damaging to the finish.
Do not immerse the appliance in water or any other liquid, or hold it under a
running tap to clean.
To remove stubborn spots/marks, wipe the surfaces with a cloth slightly
dampened in soapy water or mild non-abrasive cleaner. Rinse and dry a clean,
dry, soft cloth.
After using, lift the iron with the filling hole downwards to empty the remaining
water from the Water tank.
Insert the plug into the socket, and set the Temperature Control Dial to “MAX” for
1-2 minutes to evaporate the remaining water, and then unplug the iron and let it
cool down before storing it.
SELF-CLEANING
The iron needs to be self-cleaned every 10-15 days:
Push the steam control turning knob (C) to “O” position.
Set the temperature control dial (I) in “MAX” position and plug the power plug in
until the pilot light (G) lights up.
Unplug the power plug, and hold the iron over a sink or basin immediately.
Hold the self-cleaning button (L), the water will drip down from the steam spray
holes in the soleplate.
After the water tank is empty and no more water drip down, put the iron on a
shelf until it is dry.
STORING THE APPLIANCE
Unplug the unit from the wall outlet and clean all the parts as instructed above.
Ensure that all parts are dry before storing.
Store the appliance in its box or in a clean, dry place.
Never store the appliance while it is still wet or dirty.
Never wrap the power cord around the appliance.

8
SERVICING THE APPLIANCE
There are no user serviceable parts in this appliance. If the unit is not operating
correctly, please check the following:
You have followed the instructions correctly
That the unit has been wired correctly and that the wall socket is switched on.
That the mains power supply is ON.
That the plug is firmly in the mains socket.
If the appliance still does not work after checking the above:
- Consult the retailer for possible repair or replacement. If the retailer fails to resolve the
problem and you need to return the appliance, make sure that:
The unit is packed carefully back into its original packaging.
Proof of purchase is attached.
A reason is provided for why it is being returned.
If the supply cord is damaged, it must be replaced by the manufacturer or an authorised
service agent, in order to avoid any hazard. If service becomes necessary within the
warranty period, the appliance should be returned to an approved Home of Living
Brands (Pty) Limited service centre. Servicing outside the warranty period is still
available, but will, however, be chargeable.
CHANGING THE PLUG
Should the need arise to change the fitted plug, follow the instructions below.
This unit is designed to operate on the stated current only. Connecting to other
power sources may damage the appliance. Connect a three-pin plug as follows:
The wires in this mains lead are coloured in accordance with the following code:
Green/Yellow = Earth
Blue = Neutral
Brown = Live

9
PLEASE AFFIX YOUR PROOF OF PURCHASE/RECEIPT HERE
IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE PRODUCED.
W A R R A N T Y
1. Home of Living Brands (Pty) Limited (“Home of Living Brands”) warrants to the
original purchaser of this product (“the customer”) that this product will be free
of defects in quality and workmanship which under normal personal, family or
household use and purpose may manifest within a period of 1 (one) year from
the date of purchase (“warranty period”).
2. Where the customer has purchased a product and it breaks, is defective or
does not work properly for the intended purpose, the customer must notify the
supplier from whom the customer bought the product (“the supplier”) thereof
within the warranty period. Any claim in terms of this warranty must be
supported by a proof of purchase. If proof of purchase is not available, then
repair, and/or service charges may be payable by the customer to the supplier.
3. The faulty product must be taken to the supplier's service centre to exercise the
warranty.
4. The supplier will refund, repair or exchange the product in terms of this warranty
subject to legislative requirements. This warranty shall be valid only where the
customer has not broken the product himself, or used the product for something
that it is not supposed to be used for. The warranty does not include and will not
be construed to cover products damaged as a result of disaster, misuse,
tamper, abuse or any unauthorised modification or repair of the product.
5. This warranty will extend only to the product provided at the date of the
purchase and not to any expendables attached or installed by the customer.
6. If the customer requests that the supplier repairs the product and the product
breaks or fails to work properly within 3 (three) months of the repair and not as
a result of misuse, tampering or modification by or on behalf of the customer,
then the supplier may replace the product or pay a refund to the customer.
7. The customer may be responsible for certain costs where products returned are
not in the original packaging, or if the packaging is damaged. This will be
deducted from any refund paid to the customer.
HOME OF LIVING BRANDS (PTY) LTD (JOHANNESBURG)
JOHANNESBURG TEL NO. [phone]
CAPE TOWN TEL NO. [phone]
DURBAN TEL NO. [phone]
www.russellhobbs.co.za

10
Félicitations pour l'achat de notre fer à repasser à vapeur Russell Hobbs. Chaque unité
est fabriquée avec un souci de sécurité et de fiabilité. Avant d’utiliser cet appareil pour
la première fois, merci de lire le manuel d’instructions et de le conserver afin de pouvoir
vous y reporter à l’avenir.
MESURES DE SECURITE IMPORTANTES
Lorsque vous utilisez n’importe quel appareil électrique, les précautions de sécurité de
base devraient toujours être suivies, y compris les points suivants :
1. Merci de lire les instructions avec attention avant d’utiliser un appareil quel qu’il
soit.
2. Toujours vous assurer que le voltage inscrit sur l’étiquette de classification
correspond aux voltages principaux de votre habitation.
3. Un mauvais fonctionnement et une utilisation inappropriée peuvent
endommager l’appareil et peuvent entraîner des blessures pour l’utilisateur.
4. L’appareil est uniquement destiné à un usage domestique. Une utilisation
commerciale annule la garantie et le fournisseur ne peut pas être tenu pour
responsable en cas de blessures ou de dommages causés lors d’une utilisation
différente de celle pour laquelle cet appareil est destiné.
5. Eviter tout contact avec les parties articulées.
6. Cet appareil n’est pas conçu pour être utilisé par des personnes (y compris les
enfants) dont les capacités physiques, sensorielles ou mentales sont déficientes,
ou bien, ne possédant pas assez d’expérience ou de connaissance, à moins
qu’elles n’aient été supervisées ou qu’elles aient reçu des instructions relatives à
l’utilisation de l’appareil, par une personne responsable de leur sécurité.
7. Les enfants devraient être supervisés afin de s’assurer qu’ils ne jouent pas avec
l’appareil.
8. Vérifier le cordon d’alimentation et le brancher régulièrement afin d’éviter tout
endommagement. Si le cordon ou la prise sont endommagés, ils doivent être
remplacés par le fabricant ou par une personne qualifiée, afin d’éviter un risque
électrique.