Russell Hobbs 18089 User manual

27 Slide the filter down into the guides.
28 Replace the lid.
DWIRING UK PLUGS
The product must be earthed. It
has a 13A BS1362 fuse in a 13A
BS1363 plug. To replace the plug,
fit the green/yellow wire to Eor E,
the blue wire to N, and the brown
wire to L. Fit the cord grip.
If in doubt, call an electrician.
Don’t use a non-rewireable plug unless the
fuse cover is in place. If you remove the plug,
dispose of it.
HENVIRONMENTAL PROTECTION
To avoid environmental and health problems
due to hazardous substances in electrical and
electronic goods, appliances marked with
this symbol mustn’t be disposed of with
unsorted municipal waste, but recovered,
reused, or recycled.
SSERVICE
If you ring Customer Service, please have the
Model No. to hand, as we won’t be able to
help you without it. It’s on the rating plate
(usually underneath the product).
The product isn’t user-serviceable. If it’s not
working, read the instructions, check the plug
fuse and main fuse/circuit breaker. If it’s still
not working, consult your retailer.
If that doesn’t solve the problem – ring
Customer Service – they may be able to offer
technical advice.
If they advise you to return the product to us,
pack it carefully, include a note with your name,
address, day phone number, and what’s wrong.
If under guarantee, say where and when
purchased, and include proof of purchase (till
receipt). Send it to:
Customer Service
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester M35 0HS
email: [e-mail]
telephone: [phone] (local rate number)
EGUARANTEE
Defects affecting product functionality
appearing within two years of first retail
purchase will be corrected by replacement or
repair provided the product is used and
maintained in accordance with the instructions.
Your statutory rights are not affected.
Documentation, packaging, and product
specifications may change without notice.
IONLINE
www.russellhobbs.co.uk for more products
551-242
instructions

Read the instructions, keep them safe, pass
them on if you pass the kettle on. Remove all
packaging before use.
AIMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 The kettle must only be used by or under
the supervision of a responsible adult. Use
and store the kettle out of reach of children.
2 Don’t put the kettle, stand, cable, or
plug in liquid; don’t use the kettle in
a bathroom, near water, or outdoors.
3 Unplug the stand when not in use.
4 Keep the kettle, stand, and cable away from
the edges of worktops.
5 Take care when removing the lid – steam
will escape from the opening.
6 Switch off before opening the lid.
7 Put the stand on a stable, level surface.
8 Wind excess cable beneath the stand.
9 Don’t use the kettle without fitting the filter.
10 Use the kettle only with the stand supplied.
11 Don’t use the kettle for any purpose other
than heating water.
12 Don’t use it with a timer or remote control.
13 Don’t use the kettle if it’s damaged or
malfunctions.
14 If the cable is damaged, return the kettle, to
avoid hazard.
household use only
UBEFORE FIRST USE
•Fill to max, boil, discard the water, and rinse.
CFILLING
caution steam escapes when you lift the lid
1 To minimise exposure to steam, grip the rear
of the handle with one hand.
2 Grip the lid knob with the other hand.
3 Pull the lid up and away from the kettle.
4 Fill with at least 2 cups of water, but don’t fill
above max.
5 If overfilled, the kettle may spit boiling water.
6 Replace the lid, press down, to lock it closed.
CSWITCHING ON
7 Plug the stand into the wall socket.
6 Put the kettle on the stand.
8 Move the switch to 1– the light will glow,
and the kettle will heat up.
CSWITCHING OFF
9 When it boils, the kettle will switch off.
10 To switch off manually, move the switch to
0, or simply lift the kettle off the stand.
CGENERAL
11 Pour slowly and don’t over-tilt the kettle.
12 Don’t tilt the kettle backwards, water might
get on to the control area.
13 If this happens, sit the kettle somewhere
warm for 12 hours to dry before using it.
14 Don’t worry about moisture on the stand.
The steam used to switch the kettle off is
condensed and vented under the kettle.
15 Don’t worry about discolouration on the
floor of the kettle. It’s due to the bonding of
the element to the kettle floor.
FUSE WITH INSUFFICIENT WATER
16 This will shorten the life of the element. A
boil-dry cut-out will switch the kettle off.
17 To avoid cycling on and off, take it off the
stand, and leave it to go completely cold.
CCARE AND MAINTENANCE
18 Unplug the stand, and let the kettle cool.
19 Wipe inside and outside with a damp cloth.
20 Keep all connectors and sockets dry.
CDESCALE REGULARLY
21 Descale regularly, (at least monthly). Use a
descaler suitable for use in plastic products
(most products have plastic parts). Follow
the instructions on the package of descaler.
, Products returned under guarantee with
faults due to scale will incur a repair charge.
CCLEANING THE FILTER
22 Switch the kettle off, and let it cool.
23 Remove the lid.
24 Pull the filter out of its guies.
25 Brush the filter, under a running tap.
26 Rinse the kettle, to remove scale particles.