Russell Hobbs RHK2 Manual

spout
handle
lid
lter
steam insert
and
MAX mark
On/O
switch
Power on
light
stand
connector
2
power cord
lid knob

Read these instructions before using your kettle. Keep this in asafeplacefor future reference. When
using electrical appliances, basic safety precautions shouldalwaysbe followed, including the
ollowing:
1. Toprotectagainst electrical hazards do not immerse the power cord, plug, stand, or kettle
in water or any other liquid.
2. Donot use in the bathroom or near any sourceof water. Donot use outdoors.
3. Alwaysuse the appliances handles as some parts may be hot.
6. Donot operate this appliancewith adamaged cord/plug or after the appliancehas
malfunctioned, dropped or damaged in any manner. ContactCustomer Servicefor
replacement, examination, repair or adjustment.
7. There are no user serviceableparts. If power cord or applianceis damaged, it must be
8. Donot use on an inclined plane or unstablesurface.
9. Donot operate the kettleunless the element is fully immersed.
10. Donot movethe kettlewhileit is switched on.
11. Donot open the lid whilethe water is heating or boiling. Ensure the lid is properly closed;
12. Alwaystake care when pouring. Pour slowly, do not over tiltthe kettle.
13. The scalding hazard remains long after the water has boiled. Keep the kettle, the stand, and
the power cord away from the edge of tableor countertops and out of reachof children
15. Only use the kettlewith the power stand provided and viceversa.
16. Donot let the cord hang over any tableor countertop edges. Wind excess cablebeneath
the stand.
17. Donot placeon or near any heat sources.
18. Donot use this appliancefor other than its intended purpose of heating water.
19. Donot switchon the kettleunless there is at least two cups of water.
22. Donot leavethe productunattended when in use or where it may be touched by children
23. Caution: Toprevent damage to the appliancedo not use alkaline cleaning agents when
cleaning, use asoftcloth and amilddetergent. Follow the instructions when cleaning this
appliance.
24. This applianceis not atoy. Children shouldbe supervised to ensure they do not play with
the appliance.
25. This applianceis not intended to be operated by means of an external timer or separate
remote control system.
26. De-scalethe kettleregularly to ensure proper operation.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY
3
IMPORTANT SAFEGUARDS

BEFORE USE
Remove all packaging from the kettle and its stand. Before using the kettle for
the first time, fill to the MAX mark, boil, then discard the boiled water. Do this
three times, then rinse the kettle out with cold water. This should remove any
dust, residues, etc. from the kettle.
HOW TO USE
Positioning
Position the stand on a flat stable surface, as close to a wall socket as possible.
Route the power cord so that it does not overhang the work surface, and cannot
be caught accidentally.
Opening the lid
Warning: If the kettle has just boiled, it will be full of steam, which will escape
as soon as the lid is opened. Keep your hands, face, etc. clear of the area above
the kettle.
Check that the switch is in the ‘Off’ (up) position.
Remove the kettle from the stand and set it down on a flat stable surface.
Grasp the lid knob then lift the lid up and away from the kettle, to prevent the
steam swirling round your hand.
Filling
Remove the kettle from the stand. Remove the lid and fill the kettle via the
lid aperture. Fill with at least 2 cups of water, but do not allow the water level
to rise above the MAX mark on the inside of the kettle.
Do not overfill the kettle. If the kettle is overfilled, boiling water may be ejected.
Check that the filter is in place. Replace the lid, and check it is fully closed,
otherwise the kettle may not switch off when it boils.
4
Switching on
Check that the switch is in the ‘Off’ (up) position.
Plug the stand into the wall socket. Switch the socket on.
Gently position the kettle on the stand, taking care not to spill any water.
Press the switch down. The Power-on indicator light will light up, and the
kettle will start to heat up.
When the water has boiled the kettle will switch off automatically, the switch
will return to the ‘Off’ position and the light will go out.
The kettle can be switched off at any time before the water boils by pressing
the switch up.

5
General
When you lift the kettle from the base, you may see moisture on the surface
of the base. This is the steam used to switch the kettle off automatically,
which then condenses and is allowed to escape via vents in the underside of
the kettle. This is perfectly normal, and should not be a cause for alarm.
Important: Ensure that the kettle has switched off automatically, or is
switched off manually and is disconnected, before moving it.
Remove the kettle from the stand before attempting to pour.
When filling or carrying the kettle, do not tilt it backwards, as this may allow
water to pass through the steam aperture on to the control area. Should this
occur, the kettle must be allowed to dry before use. Sit it somewhere warm
for 12 hours before re-use. To avoid the risk of splashing, pour slowly and do
not over-tilt the kettle.
Insufficient water
Do not switch the kettle on unless it contains at least two cups of water.
Misuse of this kind will shorten the life of the element and your kettle.
If the kettle is accidentally switched on when it does not contain sufficient
water, a boil-dry device will automatically switch it off. Unplug and remove
the kettle off the stand and wait until the kettle has cooled down fully before
filling, as the element will be hot and spitting may occur. If you leave it on
the stand, plugged in after a boil-dry, it will cycle on and off until the element
burns out.

CARE AND CLEANING
Cleaning
Switch the kettle off (press the switch up), unplug the stand from the wall
socket, and let the kettle cool down completely before cleaning.
Remove the kettle from the stand.
Wipe the stand, outside and inside surfaces of the kettle with a damp cloth. If
necessary, you may use a little household detergent.
If you use detergent inside the kettle, rinse thoroughly afterwards to remove
all trace of the detergent and avoid tainting the water.
Ensure that all connectors and sockets are kept dry.
Do not immerse the kettle or stand in water or any other liquid.
Do not use harsh or abrasive cleaners or solvents.
6
Descale regularly – even in soft water areas
Limescale may be white, coloured, even rusty-looking, but it’s normally
visible.
Phosphate scale isn’t generally visible, but it’s there, even in soft water areas.
When water is heated, the minerals solidify. This makes the water appear
cloudy. It may form a film on the surface of the water or on the walls and floor
of the kettle. It may look like thin pieces of plastic in the water.
All scale causes overheating, reduces the kettle’s life, and may trigger the
boil-dry cut-out.
So, even with soft water, descale regularly, to help keep your kettle in working
order.
Use a descaler suitable for plastic products (all kettles have plastic parts).
Follow the instructions provided with the descaler, rinse several times, then
fill, boil and discard the water, to ensure no residues are left. Alternatively,
you may use white vinegar. Fill the kettle with half a litre of vinegar and leave
it to stand for 1 hour without heating.
Also citric acid can be used. Boil a litre of water, add 25g of citric acid and
leave it to stand for 15 minutes.
After descaling, rinse several times, fill, boil and disard the water, to remove
all chemical residues.
*Products returned under guarantee with faults due to scale will be subject to
a repair charge.

Water filter
The scale particles that remain suspended in the water may give it a cloudy or
greasy appearance, depending on the hardness of the water. The filter fitted to
your kettle will prevent these particles passing into your drink. You must
ensure that the filter is kept clean and clear of deposits, otherwise the per-
formance of your kettle may be adversely affected, your drinks may contain
scale particles, and the water inside the kettle may look cloudy.
You should clean the filter whenever there are any noticeable deposits left on
it, and especially if pouring is affected in any way.
Make sure that your hands are clean and free from soap, hand cream, or any-
thing else which might leave a taint.
7
Switch the kettle off (press the switch up), unplug it from the wall and let the
kettle cool down completely.
Open the lid.
Prize the filter from the spout by pushing through the spout and remove it from
the kettle. Rinse it under a tap whilst brushing it with a soft brush. Rinse the
kettle out with fresh water, in case any scale particles have fallen inside.
To replace, look through the spout and align the sides of the filter inside the
kettle then push firmly back into place.

8
CUSTOMER SERVICE
AUSTRALIAN CUSTOMER SERVICE
Salton (Aust) Pty. Ltd.
P.O. Box 683
Braeside Victoria 3195
Australia
Freecall: 1800 427 842
Hours: 9am - 5pm (EST) Mon - Fri
NEW ZEALAND CUSTOMER SERVICE
Salton NZ Limited
P.O. Box 300 201
Albany, Auckland
New Zealand
Freecall: 0508 629 777
Hours: 9am - 5pm Mon - Fri
File: RHK2_IB_060709
2 year warranty
Nothing in this guarantee or the instructions relating to the product excludes,
restricts or otherwise affects your statutory rights under the Trade Practices Act
1974 and other relevant legislation.
In addition to your statutory rights, Salton (Aust) Pty Ltd and Salton NZ Ltd
(hereafter referred to as “Salton”) provide a LIMITED 2 YEAR WARRANTY for this
product. Salton warrants this product free from defects in material and workman-
ship for two (2) years from the date of purchase.Within this warranty period Salton
will repair or replace defective parts at no charge. Defective products may be
returned to Salton or the place of purchase. Salton recommends you keep your
receipt as proof of purchase. If distance prevents you from taking the product to
the place of purchase, please call the Salton customer service department freecall
within Australia 1800 427 842, or freecall within New Zealand 0508 629 777.
The warranty does not cover improper installation, misuse, abuse or neglect of the
product. This warranty also does not cover any product taken apart, altered or
serviced by an unauthorised repairer.
Registration of your warranty card is not compulsory, but entitles you to receive
these benefits:
,QIRUPDWLRQRQVSHFLDOSULFHRIIHUVDQGSURPRWLRQV
1RWLILFDWLRQRIDQ\LVVXHVFRQFHUQLQJ\RXUSURGXFW
To register your product please:
Visit www.salton.com.au/warranty OR
)LOOLQWKHZDUUDQW\FDUGEHORZDQGVHQGLWWRWKHDGGUHVVVKRZQEHORZ