Russell Hobbs RHGT17 Installation guide

INSTRUCTIONS AND WARRANTY
MODEL NO. RHGT17

2
RUSSELL HOBBS TWO SLICE GLASS PANEL TOASTER
Congratulations on purchasing our Russell Hobbs Two Slice Glass Panel Toaster. Each
unit is manufactured to ensure safety and reliability. Before using this appliance for the
first time, please read the instruction manual carefully and keep it for future reference.
FEATURES OF THE RUSSELL HOBBS TWO SLICE GLASS PANEL
TOASTER
•With brushed stainless steel accents and clear glass front for easy viewing
•Cancel, Bagel & Browning buttons for control selection
•Auto shut-off & electronic pop up
•2 Removable crumb trays
•38mm wide slots for all types of bread
•Easy release & anti-jam
•900W
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be followed
including the following:
1. Please read the instructions carefully before using any appliance.
2. Always ensure that the voltage on the rating label corresponds to the mains
voltage in your home.
3. Incorrect operation and improper use can damage the appliance and cause injury
to the user.
4. The appliance is intended for household use only. Commercial use invalids the
warranty and the supplier can not be held responsible for injury or damage
caused when using the appliance for any other purpose than that intended.
5. Avoid any contact with moving parts.
6. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and

3
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
7. Children should be supervised to ensure that they do not play with the appliance.
8. Close supervision is required when any appliance is used near or by children or
invalids.
9. Check the power cord and plug regularly for any damage. If the cord or the plug
is damaged, it must be replaced by the manufacturer or a qualified person in
order to avoid an electrical hazard.
10. Do not use the appliance if it has been dropped or damaged in any way. In case
of damage, take the unit in for examination and/or repair by an authorised service
agent
11. To reduce the risk of electric shock, do not immerse or expose the motor
assembly, plug or the power cord to water or any other liquid.
12. Never immerse the unit in water or any other liquid for cleaning purposes.
13. Remove the plug from the socket by gripping the plug. Do not pull on the cord to
disconnect the appliance from the mains. Always unplug the unit when not in
use, before cleaning or when adding or removing parts.
14. The use of accessory attachments that are not recommended or supplied by the
manufacturer may result in injuries, fire or electric shock.
15. A short cord is provided to reduce the hazards resulting from becoming
entangled in or tripping over a longer cord.
16. Do not let the cord hang over the edge of a table or counter. Ensure that the cord
is not in a position where it can be pulled on inadvertently.
17. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas
or electric burner or in a heated oven.
18. Do not use the appliance on a gas or electric cooking top or over or near an open
flame.
19. Use of an extension cord with this appliance is not recommended. However, if it
is necessary to use an extension lead, ensure that the lead is suited to the power
consumption of the appliance to avoid overheating of the extension cord,
appliance or plug point. Do not place the extension cord in a position where it can
be pulled on by children or animals or tripped over.
20. This appliance is not suitable for outdoor use. Do not use this appliance for
anything other than its intended use.

4
21. DO NOT carry the appliance by the power cord.
22. Do not leave this appliance unattended during use. Always unplug the unit when
not in use or before cleaning.
23. Always operate the appliance on a smooth, even, stable surface. Do not place
the unit on a hot surface.
24. The manufacturer does not accept responsibility for any damage or injury caused
by improper or incorrect use, or for repairs carried out by unauthorised
personnel.
25. In case of technical problems, switch off the toaster and do not attempt to repair
it yourself. Return the appliance to an authorised service facility for examination,
adjustment or repair. Always insist on the use of original spare parts. Failure to
comply with the above mentioned pre-cautions and instructions, could affect the
safe operation of this machine.
26. When using only one of the toasting slots, don’t let anything get into the other
slot, as both slots will become “live” when you lower the bread carriage handle.
27. Don’t let the toasting slots become covered during toasting.
28. If bread gets jammed, unplug the toaster, let it cool down fully, then carefully
remove the bread that’s jamming it. Don’t use anything sharp, such as a knife or
fork, you may damage the elements.
29. Don’t toast “buttered” items or try to make toasted sandwiches in the toaster, as
this will create a fire hazard.
30. Don’t use torn, curled up, or broken slices of bread, as these may jam the eject
mechanism.
31. Unplug the toaster when not in use, before moving and before cleaning. Let it
cool down fully before cleaning and storing away.
32. Clean the crumbs out of your toaster frequently. A build up of crumbs is
unhygienic and could cause a fire hazard.
33. Don’t use the toaster unless the crumb tray is in place and closed.
34. Don’t use the toaster for any purpose other than those described in these
instructions.

5
PARTS DIAGRAM
1. Bread carriage lever
2. 2-slice long toasting slot
3. Frozen button
4. Reheat button
5. Bagel button
6. Browning control dial (settings 1 to 7)
7. Cancel button
8. Inner glass window cavity –gently remove for cleaning
9. Cord wrap under base
10. Removable crumb tray

6
OPERATING INSTRUCTIONS
Before using for the first time
1. Ensure all packaging, swing tags and promotional labeling has been removed
from the toaster and check that the toasting slots are empty before connecting to
the wall power outlet.
2. Position your toaster in a well-ventilated area, on a firm, level, heat-resistant
surface, clear of curtains, drapes and other combustible materials.
3. Plug the power cord into the wall power outlet and switch on.
4. Turn the browning control to the highest setting (7).
5. Now operate the toaster (without any bread inside) by pressing down the bread
carriage lever until it locks into place. This process will cure the new elements
and burn off any dust, residues, etc., which may have accumulated on the
elements. The new elements may give off an odour and a small amount of
vapour whilst burning in; this is normal. The toaster will shut itself off after a few
minutes. It is now ready for toasting.
Positioning
1. Position your toaster on a firm, level, heat-resistant surface, clear of curtains,
drapes and other combustible materials.
2. Do not place the toaster on or near items that may become damaged even by
moderate sources of heat.
3. Shorten the power cord by wrapping the excess cord around the clips
underneath the toaster.
Toasting bread
1. Plug the power cord into the wall power outlet and switch the outlet on.
2. Set the browning control to the desired level (1 to 7).
3. Place the bread into the toasting slot.

7
4. Operate the toaster by pressing the bread carriage lever down until it locks into
place. It will not lock down unless the toaster is connected to the electricity
supply.
5. The toaster will cook the toast for a period of time according to the position of the
browning control. Note: Bread may burn, so always monitor the cooking
process.
6. When done, the toast will pop up and the toaster will switch off.
Cancel
To stop the toaster mid-cycle, press the Cancel button.
The toast will pop up and the toaster will switch off.
Extra Lift
The bread carriage lever can be lifted manually, so smaller items can be easily removed
from the toasting slot.
Frozen Bread
1. Leave the browning control at your preferred setting.
2. Place the frozen bread into the toasting slot.
3. Lower the bread carriage lever.
4. Press the Frozen button for bread or Frozen and Bagel buttons for bagels or
muffins. Note: English muffins will need to be cut in half prior to placing in the
toaster.
5. The relevant buttons will illuminate to indicate the functions that have been
selected, and the toasting time will be altered to give the same degree of
browning you get with unfrozen items.
6. When done, the toast will pop up and the toaster will switch off.

8
Bagel Function
1. This function switches off the rear elements.
2. Place the side you want toasted facing the front of the toaster, so it is visible
through the glass.
3. Insert the bagel into the toasting slot.
4. Press the bread carriage lever down until it locks into place. The bread guides
will automatically adjust to hold the bagel slices in place.
5. Press the Bagel button - the bottom of the bagel will warm and the top of the
bagel will toast.
6. When toasting is complete, the toasted items will pop up and the toaster will
switch off. Note: The Bagel button will illuminate until the toast cycle is complete
or until the Cancel button is pressed. If the wrong button is selected, press the
Cancel button and re-select the desired cycle.
Reheating Toast
Note: You must only reheat plain, “unbuttered” toast.
Insert previously toasted food into slot.
There is no need to adjust the toast shade selector.
Press the bread carriage lever down until it locks into place.
Press the Reheat button.
When reheating is complete, the toast will pop up and the toaster will switch off.
Note: When selecting Defrost, Bagel or Reheat function, you must press the
bread carriage lever down before selecting one of these settings.
Note: If the wrong button is selected, press the Cancel button and re-select the
desired cycle.
Hints and tips
When toasting more than one slice of bread, use slices of similar size, thickness
and freshness.
Old or thin bread will cook faster than fresh or thick bread, so use a lower setting.

9
Do not use torn, curled up, or misshapen slices of bread, as these may jam the
ejection mechanism and could catch fire.
Sweet bread products (fruit loaf, etc.) brown much quicker than ordinary bread,
so should be toasted on a lighter setting.
Should the bread carriage become jammed during the toasting cycle, do not
attempt to release it. Unplug the toaster and allow it to cool down before carefully
removing the bread.
Do not insert a knife, fork or similar sharp instrument into the toaster as these
may damage the elements and present a danger of electric shock.
Crumbs
Crumbs will collect in the base of the toaster. Letting them build up can cause a
fire hazard so it is important to remove them frequently.
Switch off the power and remove the plug from the wall power outlet.
Pull out the crumb tray and empty out the crumbs.
Wipe the tray clean with a damp cloth.
Dry thoroughly before sliding back into the base of the toaster.
Inner Glass Window
The inner glass window may require occasional cleaning.
Switch the power off and remove the plug from the wall power outlet.
The toaster must not be hot.
Lay the toaster on its back.
Insert fingers into the latch, squeeze latch to unlock and withdraw the glass
window from the toaster.
Wash window in warm soapy water, rinse and dry thoroughly.
Slide the window back into the window cavity taking note of the orientation marks
on the latch.
Note: For safety reasons the toaster will not operate without the inner window installed.

10
Jamming
If the bread jams in the toaster, the contacts will open and turn off the power to the
elements. You should still unplug the toaster and leave it to cool down before trying
to release the jam.
Cleaning and Maintenance
This toaster is for household use only and is not user-serviceable.
Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.
Always remember to switch the power off and unplug the toaster from the electrical
outlet when not in use and before cleaning.
Let the toaster cool down fully before attempting any cleaning operation or storing
away.
The body of the toaster and the crumb tray should be cleaned with a damp cloth.
Do not let water enter the toaster.
Don’t let anything (e.g. cleaning utensils, liquid or any foreign objects) enter the
slots, you might damage the elements and present a danger of electric shock.
Remove, empty, clean and refit the crumb tray.
Remove, clean and refit inner glass window.
Do not use bleach or other abrasive substance or solvents to clean your toaster as
it can be damaging to the finish.
To remove stubborn spots/marks, wipe the surfaces with a cloth slightly dampened
in soapy water or mild non-abrasive cleaner. Rinse and dry with a clean, dry, soft
cloth.
Do not immerse the toaster in water or any other liquid.
Storing the appliance
Unplug the unit from the wall outlet and clean all the parts as instructed above.
Ensure that all parts are dry before storing.
Store the appliance in its box or in a clean, dry place.