RVLock R005V User manual

R005V
Remote control manual
Warning
Do not expose the remote control to damp air.
Do not throw the remote control from high altitude.
Be careful not to let children and pets touch the remote control.
This remote control uses a scrolling code. Please use the remote control code
according to the operating instructions of the external wireless receiving device.
The control of the remote control is achieved by briefly pressing the
corresponding button.
LED indicator light: Press the button to light up the indicator light, and it will turn
off within 3 seconds after being released; When the battery level is low, press the
button to dim the LED brightness, and at the same time, the remote control
distance becomes closer; Stop working when the battery level is below 2.3V.

During the disposal process, current normative documents formulated by local
legislative bodies should be followed.
Technical Parameter
Working Mode：OOK
Operating Frequency：433.94MHz
Radiation Intensity：Not exceeding 2mW
Remote Control Distance（20±5）°С：Open environment greater than 80 meters
Battery Model：CR2032
Working Voltage：3V
Ambient Temperature：-20°С ~ +50°С
Size：65x33x14mm
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help This device
complies with part 15 of the FCC rules. Operation is subject to the following two
conditions
(1)this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation。