Sachtler Adaptor Aktiv Slider S2080-0005 User manual

Part No.S2080-0005 (75 mm) S2080-0006 (100 mm)
Adaptor aktiv slider / tripod 75 mm - 100 mm
!
Refer to aktiv system manual S2068-4980 for safety
instructions, and information regarding adjusting the aktiv bowl
connector
!
a
b
c
Hold the adaptor rmly with both hands. Pull the lever all the way back
towards the level bubble.
Lower the Adaptor onto the aktiv bowl stud and release the lever, the lever
should return to the locked position as shown below.
Attach the sideload plate to the underside of the slider using the screws provided and
tighten the screws rmly.
Remove the sideload plate.
a. Loosen the red clamp knob
b. Press the red release button
c. Lift out the sideload plate
Locked Position
Max. payload: 10 kg (22 lb) for slider with 60 cm (23.6 in) length.
Please check the maximum payload specied by the slider manufacturer.

Publication Part No. S2080-4982/0
www.sachtler.com
Place the camera plate with the slider tted into the dovetail and lower into
place.
It will lock automatically and the lock lever will click audibly back into its
initial position.
Note! The Tripod and slider has been removed from the diagram for clarity.
Firmly lock the plate in position using the red clamp knob.
To level the assembly pull the lever until the adaptor moves freely,
do not pull the lever too far as the adaptor could be released from
the tripod.
With the lever held in the mid position centre the bubble and
release the lever back into the locked position.
Locked Position
Unlocked position
Levelling Position
When head is tted to the slider you may use the same procedure
to ne adjust and check the level.
When tting an aktiv head onto the the slider, adaptor S2080-0003
(75mm head) or S2080-0004 (100 mm head) will be required.