SACKit WOOFit User manual

WOOFit
User Manual

1
UK
Box Contents
- WOOFit speaker
- User manual
- 2-in-1 charging cable
- Storage bag
- Micro USB antenna
Thank you!
Thank you for purchasing this
WOOFit speaker from SACKit.
Please read this manual carefully before
use. We are not responsible for any
person or property damage caused by
improper use of this product. We hope
you enjoy the louder, richer sound, and
features from your WOOFit device.
Please save this user manual for later
supervision and guidance securing
correct use of the product.
Embrace life with your new SACKit
product!
Remember
Remember to register your new
SACKit product on our website:
www.SACKit.eu/reg

Quick Start Guide
2
UK
1. Charge the WOOFit Speaker using
the included micro USB charging
cable for no less than 2 hours
2. Turn on WOOFit
3. Turn on Bluetooth on the device you
wish to connect with
4. Choose SACKit in the Bluetooth
sengs on your device
5. Start playing music from your device
6. Enjoy the music and dance

3
UK
Micro USB
input
Micro SD PlayerMini Jack
input/
AUX out
Power buon
- Micro USB input
- Mini jack input
- AUX out
- Micro SD player
- Power buon
- Light indicator
- Microphone
- M (Mode) buon
- Play/Pause buon
- Volume (-) buon
- Volume (+) buon
Mode
Play/Pause Volume +
Volume -
Light indicator
Microphone

4
UK
Power buon
This buon must be slided right to turn
on the WOOFit speaker, and to the le
to turn the device o.
M (mode) knap
Push the Mode buon to switch
between micro SD player, AUX OUT,
FM Radio and Bluetooth mode. If there
is no Micro SD card in the WOOFit
speaker, this mode will automacally be
skipped.
Play/Pause
When the device is in Bluetooth mode
a push on the Play/Pause buon will
either play or pause the music.
Volume buons (-/ +)
These buons makes it possible to
adjust the sound level. When WOOFit
is in Bluetooth mode a ”bip” sound will
be given when the sound level reaches
maximum. This warning sound will not
occur when the speaker is in AUX OUT
mode.
Buons

5
UK
To charge the WOOFit speaker, the
included Micro USB charging cable
must be inserted in the Micro USB input
on WOOFit and be connected to a
computer or an adapter.
The charging begins automacally
whether the system is on or o. The
charging status can be seen on the
light indicator. During charging the
light indicator will light up red. When
the baery is fully charged the light
indicator will light up green. A full charge
of WOOFit takes approximately two
hours.
Charging
Bluetooth
1. WOOFit is turned on by sliding the
power buon to the right. When the
light indicator alternately ashed blue
and red, WOOFit is ready for pairing
with desired device. Please noce that
pairing mode automacally will voided
aer 5 minutes if not paired. If this
happens, the WOOFit speaker will have
to be restarted.
2. Perform the connecon procedure
on your Bluetooth device to nd
the WOOFit speaker. This system is
indicated as ”SACKit”.
Connecons

6
UK
If ”SACKit” does not appear on the
list of found devices, the connecon
process must be started over. Note
that the two units should be in one
meter radius of each other during the
connecon.
3. Choose the ”SACKit” connecon on
your Bluetooth device.
4. When the connecon is established
the light indicator will ash slowly in
the colour blue. Next me the WOOFit
speaker get turned on, a connecon
will automacally be made with the last
paired device.
5.Noce: If passcode* input is
demanded on your Bluetooth device
enter ”0000”. Passcode may also appear
under the synonyms as; ” Passkey ”, ”Pin
Number” or ”Password”
Phone call
If music is playing when in the Bluetooth
mode and you have an incoming call,
WOOFit will automacally switch to
hands-free mode. Press the Play/Pause
buon to accept the call. To hang up
press the Play/Pause buon again. Two
short pushes on the Play/Pause buon
will make WOOFit redial.

7
UK
AUX connecon
Press one me on the Mode buon
to choose ”AUX OUT” as mode. The
Light indicator will now light up green.
To adjust the sound level the volume
buons +/- has to be pressed and hold
down. A short push on the +/- buons
works as Play/Pause buons in this
mode.
Mini jack input
This input enables to connect
headphone to WOOFit. When the
headphones is connected, the sound
level will be down adjusted immediately,
but within two seconds the level will
gradually increase to protect the user
from hearing damage.
Micro USB input
This input is for charging only with the
included Micro USB charging cable.
Audio and other signals can not be sent
or received from/to this input.
Micro SD player
This input enables the funcon of
playing your music directly from a Micro
SD card. Insert the Micro SD card and
press the mode buon to choose the
correct mode. The light indicator will
now ash green and blue to indicate
the correct mode. The sound level is
adjusted by holding the volume buons
down. One short push on the volume
buon will work as Play/Pause buons
in this mode.

8
UK
Home Systems
It is possible to connect WOOFit to a
home system. To do this, use a standard
stereo mini-jack (3.5 mm.).
FM Radio
To use the FM Radio, please follow this
guide.
1. Turn on your WOOFit speaker.
2. Connect the included Micro USB
antenna with WOOFit via Micro USB
input.
3. The antenna is pulled out to its full
length for opmal eect.
4. One push on the Mode buon will
switch to the FM Radio player mode.
5. The light indicator will ash blue and
green when the speaker is ready to play
your favorite radio!
Sound level adjustment
Hold down the +/- volume buons to
increase or decrease the sound level.
Channel Search
To nd available channels, briey press
the Play / Pause buon. The found
channels will be stored.
Channel Switching
To switch between the stored channels
briey press the volume buons.
+ buon will play the next channel and
- buon will play the previous channel.

No light: WOOFit speaker is turned o.
Green light: WOOFit is fully charged or
WOOFit is turned on.
Blue and green ash: Micro SD Player
is acve or FM radio is seaching for
staons.
Red and blue ash: WOOFit is searching
for Bluetooth device.
Light Indicator
Red light: WOOFit is charging.
Blue slow ash: Connecon between
WOOFit and Bluetooth device has failed.
Fast green ash: Music is playing from
Bluetooth device.
Green light with blue ash: Music is
playing from FM radio.
9
UK