SACRED BUNDLE Yoli User manual
Yoli
Change Table
IMPORTANT
PLEASE READ THE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
YL-CT-ASH
WARNING!
Serious or fatal crushing injuries can occur from furniture tip over. To
prevent tip over, this furniture must be secured with the wall attachment device(s)
provided.
Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable
for the walls in your home
If
you are uncertain, seek professional advice. Read and follow each step of the
instruction of the anchor kit carefully.
What causes tip-overs?
Some causes are illustrated below. Also remember that an uneven or sloped floor, edge of a
carpet or rug, as well as soft or thick carpets can also cause instability and tipping accidents.
When we develop furniture, we do everything we can to make it as stable and safe as possible. Be
we can't outsmart the laws of physics. Like the fact that when the center of gravity of a piece of
furniture shifts outside the base of the furniture, it will tip over if it is not secured. Or the fact that a
pulled-out drawer works like a lever.
Applying excessive weight on the side of the table or drawer shifts the center of gravity outside
the base of the piece of furniture and can cause a tip over.
Using the drawers as a ladder to reach an object. Putting a toy or some other attraction on top could tempt a
child to climb up. Putting a heavy object on top of a chest of drawers increases the tip-over hazard. Tipping
may also occur if a toddler sits in a drawer for play or opens all drawers out of curiosity.
FURNITURE MUST BE PERMANENTLY ATTACHED TO THE WALL USING THE ATTACHMENTS PROVIDED
ATTACHMENTS PROVIDED ARE NOT A SUBSTITUTE TO ADULT SUPERVISION
WARNING!
DO NOT LEAVE CHILD UNATTENDED WHILE USING
THIS CHANGE TABLE
CHANGE TABLE IS NOT FOR SLEEPING
Sacred Bundle Pty Ltd. ABN 47631902479
5/108 Dover Drive, Burleigh Heads, QLD, 4220.
Phone: +61 4 3436221 +61 4 23688138
Email: [email protected]
www.sacredbundle.com.au
Yoli Change Table - YL-CT-ASH
Assembled Dimensions
1155L x 5 50D x 850H mm
Material: Natural Ashwood
Pas List
0
Assembly
No Assembly Needed.
Install wall Anchors. Anchors must be placed on both sides of the change table.
Please refer to instructions provided with the anchor kit for correct
installation.
ANCHOR1
YL-CT-ASH
CARE & MAINTENANCE
Congratulations and thank you for choosing Sacred Bundle product(s). The furniture you
have purchased is constructed from high quality materials for strength and durability.
Here are some tips on how you can preserve its beauty for a long time.
1. Do not expose furniture to direct heat sources, extreme changes in
temperature or moisture. This item should not be placed directly next to air-
conditioning, outlets, fire places, radiators, space heaters, humidifiers, or
dehumidifiers. Exposure to extreme variations of temperature and humidity can
damage wood products.
2. Keep the change table out of direct sunlight. UV rays may fade colour and in
some cases darken them. It can cause crazing or hair line cracks in the finish.
Finishes will darken naturally over time and exposure to direct sunlight will
hasten this natural process along with some wood darkening; this is not
considered to be a quality defect.
3. Wipe up spills immediately with a soft, clean cloth.
4. Urine spills on furniture can cause discolouration.
5. Clean furniture by wiping the surface with a soft cloth dampened with water.
6. If necessary clean furniture using a mild soap solution and wipe clean with a
soft cloth dampened with water and then dry with soft clean cloth.
7. Do not use strong household cleaners.
8. Always wipe in the direction of the grain in the wood do not wipe in a circular
motion.
9. Avoid contact with sharp objects, or containers containing hot liquid.
10. When moving furniture do not drag always lift and place in position.
11. To remove any residue from assembly stickers, wipe off gently with a small
amount of rubbing alcohol on a clean cloth.
12. In case of the appearance of mildew after storage, generously spray all affected
areas with a mix of 1:10 part vinegar and water. Once the mix has been applied,
let it sit for 10 minutes and wipe clean with a dry cloth. Place the affected parts
outside in direct sunlight for 1 hour to air out and allow it to thoroughly dry.
Table of contents
