Safavieh Lighting LMR1015 User manual

WARNING
* Switch off the main electrical supply from the main fuse box / circuit.
* Breaker before installation.
* Inspect item carefully before attempting to install.
* If there is any damages or obvious defects, do not install.
* Item may not be returned once it has been installed.
*NOTE:THIS ITEM IS NOT RECOMMENDED FOR WET, DAMP OR MOIST LOCATIONS.
CARE AND MAINTENANCE
Model#: LMR1015
Product Dimensions: 26"L X 65"H X 2.25"D
* The best and safest cleaner for a mirror is clean, warm water used with a soft cloth. Becareful not to allow the
edgesofthe mirror togetorremain wet over a period oftime.
* If using a commercial glass or mirror cleaner, be sure touse a standard brand ofglass ormirror cleaner that
does not contain ammonia or vinegar. Do not use Windex. Never spray any cleaner directly on to a mirror.
Instead, apply the cleaner toa soft cloth and then wipe the mirror.
* Always use soft, grit-free cloths when cleaning a mirror to reduce chances of scratching the surface.
* Be sure to dry all joints and edges thoroughly to be certain that no commercial cleaner comes in contact with
the edges and backing.
NOTICE& IMPORTANT SAFETY INSTRUCTIONS
** WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN **
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during assembly
* To reduce the risk of fire, electrical shock or injury to persons or property, please follow the guideline below
for safe use and installation
*The external flexible cable or cord of this lamp cannot be replaced
If the cord is damaged, the lamp shall be destroyed
Part List and Hardware List
PIECE DESCRIPTION PICTURE QUANTITY PIECE DESCRIPTION PICTURE QUANTITY
A mounting screw 4X C lamp body 3X
B gecko 4X D lamp body 1X
1/3

PREPARATION
* Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
* If any part is missing or damaged, do not attempt to assemble the product.
* Estimated Assembly Time: 20 minutes.
* Tools Required for Assembly (excluded): Screw driver, Pencil, Drill with 1/4" bit, Level, Measuring Tape
* If you are having difficulty, our friendly Customer Care team is always here to help. Please email [e-mail]
NOTE: DRY LOCATION ONLY!
Option 1: Assembly instruction(portable)
Step1:Open the support behind the lamp mirror and put it on the ground, and plug in the power plug cable to power.
2/3

PREPARATION
* Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
* If any part is missing or damaged, do not attempt to assemble the product.
* Estimated Assembly Time: 20 minutes.
* Tools Required for Assembly (excluded): Screw driver, Pencil, Drill with 1/4" bit, Level, Measuring Tape
* If you are having difficulty, our friendly Customer Care team is always here to help. Please email [e-mail]
NOTE: DRY LOCATION ONLY!
Option 2: Assembly instruction(Hardwired)
Step1: Mark the position of hanging screw on the wall with pencil. Drill three hang
holes with an electric drill and fix mounting screw with gecko.
Step 2: Connect the cable to power source in wall with wire nut. Hang the mirror onto wall
screws.
3/3