Safe Fleet RGY Button User manual

© Safe Fleet 2020 | All rights reserved Part # 700-1233 R1
RGY Button
Quick Start Guide
The RGY Button’s tri-color LED light ring provides
recorder system status, and indicates video loss
conditions. The button activates an alarm/event input
to mark video. The RGY Button is compatible with
TH8, NH16, and DH series recorder platforms.
Typical Installation Package
• RGY Button with 5 ft./1.5m pigtail
(part # 065-1010)
• RGY extension harness (20ft./6m)
(part # 060-1197)
• Button & Signals harness (part # WT2)
Installation Procedure
Determine the proper location before drilling
the mounting hole. Ensure the area behind the
hole is clear of obstructions before drilling.

edges if necessary.
Remove the mounting nut from the button as
shown.

mounting hole, and re-attach the nut.
Connect the RGY Button’s 5-pin connector to
the RGY extension harness (060-1197),
Connect the extension harness to the Button &
Signal harness’ (WT2) 5-pin connector.

SIGNALS socket on the recorder.
Set up the recorder for the RGY Button (see

Recorder Conguration
Power up the recorder with a monitor and
USB mouse connected, then right-click in Live
view and select Conguration.
Select System to open System Settings.
In the Diagnostic Indicator drop-down menu,
select RGY Button.
Click Back to save changes..

Part # 700-1233 R1© Safe Fleet | All rights reserved
RGY Button Quick Start Guide
Color Recorder Status Examples
Green Recording/normal – no video loss from any
camera; no problems with recording operation
Routine operations, including:
• recording
• warming up/booting
• shutting down
Yellow Recording/video loss – recording, but
experiencing video loss from one or more
cameras
Video loss on any or all channels 1
Red Not recording – system unable to record due
to an abnormal condition
Not recording due to:
• overheating
• drive unlocked
• drive failure 2
• other abnormal conditions
1If the system is experiencing video loss and not recording, the red light displays.
2On systems with primary storage consisting of dual media, both media must fail.
TIP: Event button - tagging video


in the recorder’s Installation and Conguration
Guide
TIP: Status light colors
Vehicle operators should check that the recorder status
light turns solid green approximately two minutes after
vehicle ignition is on.
A yellow or red status light should be reported to a
supervisor, and indicates the system requires attention.
Contact Safe Fleet Technical Support
Phone: [phone]
Email: PTsupport@safeeet.net
Warranty

• www.seon.com/documents/Seon-Warranty.pdf
Service & Support

and/or serial# of your unit, and ask for a Return Merchandise Authorization (RMA) number. An RMA# allows the support
team to better track your product when it comes in for service. Please show the RMA# on the outside of the package.

Documentation

().
RGY Button - Status Light Indicators
Event button
Status light