Safe Fleet HD1Q-MP4A30 User manual

2022 | Part #: 700-0188 R11© Safe Fleet | All rights reserved
Dome Camera Mounting Post
Installation Instructions
for HD1Q, HD2Q, HD3Q, CHQ8PD, C3Q9PD,
CQ, & CJ Cameras
2002/96/EC (WEEE directive): This product cannot be disposed of as unsorted municipal waste in the Europe-
an Union. For proper recycling, return the product to your local supplier upon the purchase of equivalent new
equipment, or dispose of it at designated collection points, for more information, see www.recyclethis.info.
2006/66/EC (battery directive): This product does not contain batteries.
Service & Support
If your mounting post is to be returned for service, please contact the Safe Fleet technical support team,
provide the part and/or serial # of your unit, and ask for a Return Merchandise Authorization (RMA) number.
An RMA # allows the support team to better track your product when it comes in for service. Please show the
RMA # on the outside of the package.
ANY PRODUCT SENT WITHOUT AN RMA# MAY BE REFUSED!
Documentation and Warranty
Additional copies of this guide along with other documentation
and product warranty can be found on the Safe Fleet
Community website: 
Technical Support
Phone: [phone]
Email: PTsupportnet
Mounting Post Kit Applicable Cameras
HD1Q-MP4A30 / HD1Q-MP6A30
(angled)
HD1QxxAI
HD2Q-MP4A30 / HD2Q-MP6A30
(angled)
HD1QxxAI2, HD2QxxAI
CHQ-MP4A30 / CHQ-MP6A30
(angled)
HD3QxxA, CHQ8PDxxA
C3Q-MP6A30 (angled) C3Q9PDxxAF
CJ-MP6A30 (angled) CJ9xxA, CQ9xxA
CQ-MP4 / CQ-MP6 (at) CJ9xxA, CQ9xxA
Mounting screws
Bracket to vehicle:
• 
Camera to bracket plate: *
2 screws:
• 
• 
• 
• 
3 screws:
• 
* Quantity and type of screws vary by camera model, as shown.

Fold Here
Determine a mounting location for the camera.
Cameras must be installed with the cabling running through the post, and inside the wall panels.
Determine which 4 of the 6 available screw holes will be used to fasten the mounting post to the vehicle.
Use the base as a drilling template to lay out the drilling pattern.


Remove any sharp edges to avoid damage to cable.
Thread the camera cable from the panel hole through the post.
Using the 4 screws provided, fasten the mounting post to the vehicle panel.
Pull the camera cable through the mounting post and connect to the recorder.

Using the screws provided, attach the camera base to the mounting post.
For further camera alignment and operation details, refer to the installation guide provided with the
camera.
Installation Procedure Installation Diagrams
Camera base (CQ
model shown; dome
and cable not shown)
Attach to the vehicle
using the supplied
mounting screws
(600-0038)
Mounting post
(sample shown - ac-
tual post appearance
may differ based on
kit being installed)