Safespaces Siesta User manual

Siesta®
Assembly Instructions
01706 816274 | [e-mail] | www.safespaces.co.uk
Safespaces,361 Burnley Road, Todmorden,OL14 7DH
Company Registration No. 5733564 | VAT No. 797 1269 81

Version: 2021.2
LIST OF MATERIALS
Item
Quantity
PVC Fabric
1
Siesta Base
1
Leg Assembly with Foot
4
Base Cover Foam
1
T-Bolt and Nut (2 per leg)
8
Spring Nut and Bolt (2 per leg)
8
Mattress
1
Tools Required
1x 13mm Spanner
IMPORTANT!
READ and FOLLOW these instructions carefully.
Review all instructions before beginning assembly.
These instructions are provided to avoid problems that may occur from
improper assembly or installation.

ASSEMBLY INSTRUCTIONS
1
Fix the 4 feet bases to the aluminum uprights using M8 sliding blocks with springs,
M8 x 16mm bolts and washers.
Position the legs as shown so that the
slots in the legs match up with the corner
brackets of the bed frame.
There are two left handed feet, with the
T-bolts at the front and the spring
washers/bolts to the right.
For the right handed feet, the T-bolts are
at the front and the spring washers/bolts
are on the right hand side of the
aluminum uprights.
2
Attach a leg to the frame. The frame will
sit directly on top of the leg foot.
Locate the T-bolts attached to the frame
into the leg slot ensuring that the sliding
nuts in the other slot line up with holes in
the frame. The distance between holes is
100mm and 20mm from each end, if you
mark with a pencil these measurements
the assembly process is easier.
3
Ensure that the T-bolt is located properly in the slot ie. with the groove in the end of
the T-bolt horizontal, add the two flange nuts and tighten.
4
Screw the two M8 bolts and washers into the two spring loaded sliding nuts and
fasten.
Assembly Instructions - Siesta 1

5
The finished leg should look like this:
6
Repeat the process for the other 3 legs.
7
Sit the base cover foam on top of the
base.
8
Undo the door and corner zips of the
fabric and locate the top fabric corners on
top of the legs.
Assembly Instructions - Siesta 2

9
Attach the clips to the underneath of the
Siesta and tension floor evenly, as per
below.
10
After zipping up the doors, attach the fabric to the
legs using the corner straps with buckles.
Ensure the fabric is central on the frame whilst
tensioning the straps.
Alter the tension as necessary so the door zips
open freely.
11
Fit the loose PVC flaps around the
buckles and zip the leg as shown.
Your Siesta is now ready to use!
Assembly Instructions - Siesta 3

IMPORTANT!
For uneven floors the feet can be adjusted in height. The 4 bolts on the feet
just need to be loosened off rather than being removed. The foot will slide
up and down the leg via the slot nuts.
Read user manual before use
It is important to fully understand the content of the user manual before
attempting to use the equipment.
If you have any questions or concerns, please
call us on 01706 816274 or email [e-mail]
01706 816274 | [e-mail] | www.safespaces.co.uk
Safespaces (Cornholme) Ltd, 361 Burnley Road, Todmorden, Lancs, OL14 7DH
Company Registration No. 5733564 | VAT No. 797 1269 81
Assembly Instructions - Siesta 4