SAFETRACK S15 User manual

IN064-01
S15-Angle Head Brazing Gun

IN064-01
S15-Angle Head Brazing Gun
Adjust the height of the gun with the
adjustable rod and lock it.
Periodically maintenance of
S4-Angle Head Brazing Gun
B1.Check that all cables and lugs are
tight always twist the plug in to the
outlets on the units
B2. Check that the right pin holder is fitted in the gun.
SAFE No. For brazing pin Mark
9211 8-9,5 mm A
9213 M8 threaded B
9215 M10 threaded C
9217 M12 threaded D
Make sure that pin holder is tight to the gun.
Spanner 8mm and 10mm for 8-9,5 mm and M8 pin holders.
Two paces of spanner 10mm for M10 and M12 pin holders.
If the pinholder isn’t tight a spark can destroy the axle.
The brazing pin should not go too loose in the pin holder, when it does
push together with your fingers. Otherwise you can have a contact fault
or a spark can arise.

IN064-01
B3. Check that the ring holder is the right type.
B4. Load the gun with a 8mm pin and ferrule.
Check that the axle move easily with the pin and ferrule
fitted when moving back and forward.
If not, change either pin holder or ring-holder.
If it still doesn´t move easily the axle is damaged
And the gun must be sent for repair.
IMPORTANT! The normal lift height is 2mm (setting 0) this is
very important for the arc and energy amount. Too high lift
height increase the risk of a “cold brazing”, too low lift height
reduce the time and increase misfires.
B.5.1. Insert this end in to the gun.
B.5.2. Turn on the unit and
Important! Press the tool completely against the gun then
pull the trigger. Otherwise the gun may be damaged!
Important! Hold the gun so the tool is horizontal.
B.5.3. The lift level is calibrated when the inner rod, made of brass,
on the tool is in same level as the outer plastic sleeve.
Tolerance ±0,2 mm.
If the gun is not calibrated see separate instruction for
adjusting of the gun.

IN064-01
Advanced maintenance work
Adjusting the lift level.
B.6. Reset correct lift height on a S4 gun.
Only when to reset a maladjusted gun.
B.6.1. Fit the instrument SAFE 91245 on the
gun as in B.5.
B.6.2. Connect the cables to the Pinbrazing
unit and switch on the power.
B.6.3. Take off the plastic plug with the
needle in the upper small hole in the
front of the gun.
IMPORTANT, never adjust in the
hole where the big plug is!
B.6.4. When lift height is too low.
Use the 3mm hexagon spanner and
adjust the screw in the small hole
anti-clockwise about 1/4 of a turn
then check with the instrument as in B.5.
B.6.5. When lift height is too high.
Use the 3mm hexagon spanner and
adjust the screw in the small hole
clockwise about 1/4 of a turn then
check with the instrument as in B.5.
If all is ok, fit the plug in the hole again.
If not ok, send for repair.