Sailrite 102582 User manual

2" Swing Binder Installation
Watch video tutorials on installing &
using your Sailrite binder at Sailrite.com
#102582
B
C
E
D
1. Attach the binder to the sewing machine by inserting the two screws with the
washer Dthrough the binder slot C(not the 3 holes above the slot) into the
two holes in the bed of the machine G. Screw placement in the binder slot will
vary from machine to machine.
Afeeder mouth
Bfeeder ledge
Cbinder slot
Dscrews & washer
Ethumb screw
Fspring end
A
F
G

I
J
2. Adjust the feeder mouth Afrom front to back using the two screws next to
the feeder mouth. Position the binder as close as possible to the front of the
presser foot without touching the foot or feed dog H. The binder should not
come into contact with the foot or the feed dog when sewing. Adjust the stitch
position close to the inside edge of the binding by moving the feeder mouth
from left to right using the large thumb screw E.
3. I Feed 2" binding or tape into the wide end of the feeder mouth and use a
screwdriver blade to pull the binding completely through the slot. Sew off a
small portion of binding to test stitch position.
4. Insert the raw fabric edge that needs binding into the crease of the binding
as it exits the feeder mouth J. Feed the material tightly into the crease of the
binding and sew for a perfectly nished edge.
H