SAMSARA LUGGAGE
POWER BANK
USER GUIDE
PACKAGE CONTENTS
- Wireless Charger/Power Bank
- USB Type-C Dual Charging Cable
SAFETY INSTRUCTIONS
- Do not use the product near fire or liquids.
- Keep this product away from heat sources, including direct sunlight,
- high temperature and high humidity environments.
- Do not use this product if it has been exposed to liquids or moisture.
- Do not use if your hands are wet to prevent electric shock or injury to yourself.
- Only use this device for its intended use.
TECHNICAL SPECIFICATIONS
Power Capacity: 10000mAh @3.7V 37WH
Power Input: 5V⎓3A 9V⎓3A 12V⎓3A 15V⎓3A 20V⎓2.25A
Power Output: 5V⎓3A 9V⎓3A 12V⎓3A 15V⎓3A 20V⎓2.25A
Wireless Output: 10W
Max Output: 5V⎓4A
Power Bank will stop operating when the temperature exceeds 60°C/140°F degrees.
Working Temperature: -20°C/-4°F degrees ~ 60°C/140°F degrees.
Charging Protection (Input): Over-Voltage, Over-Charging, Over Current.
Charging Protection (Output): Over-Current, Over-Voltage, Over-Discharge,
Short Circuit.
Designed by Samsara | Assembled in China
info@samsaraluggage.com | samsaraluggage.com
62133
UN38.3
The Samsara Luggage PB2 Power Bank complies and is certified with rules and regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
