Samsung RT18M6213WW User manual
English2
Contents
Contents
Safety information 3
Important safety symbols and precautions: 3
State of California Proposition 65 Warning 3
Severe warning signs for transportation and site 3
Installation 4
Before connecting the water line 4
Install the Auto Ice Maker 5
Connect the water line 14
Troubleshooting 16
Auto Ice Maker 16
Warranty (U.S.A) 17
Warranty Information (CANADA) 19
Limited Warranty for Original Purchaser 19
Obligation to the Original Owner 19
Exclusions of the Warranty 19
Untitled-1 2 2021-09-06 10:46:59
English 3
Safety information
Important safety symbols and precautions:
WARNING
Hazards or unsafe practices that may result in severe personal injury or death.
CAUTION
Hazards or unsafe practices that may result in minor personal injury or property damage.
These warning signs are here to prevent injury to you and others.
Please follow them carefully.
After reading this section, keep it in a safe place for future reference.
State of California Proposition 65 Warning
WARNING
Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Severe warning signs for transportation and site
WARNING
• When transporting and installing the appliance, care should be taken to ensure that no
parts of the refrigerating circuit are damaged.
- Refrigerant leaking from the pipe work could ignite or cause an eye injury. If a leak
is detected, avoid any naked ames or potential sources of ignition and air the room
in which the appliance is standing for several minutes.
- This appliance contains a small amount of isobutane refrigerant (R-600a), a natural
gas with high environmental compatibility that is, however, also combustible. When
transporting and installing the appliance, care should be taken to ensure that no
parts of the refrigerating circuit are damaged.
Safety information
Untitled-1 3 2021-09-06 10:46:59
English4
Installation
Before connecting the water line
To use the ice maker, you must connect the water line to it. For the ice maker to operate
properly, a water pressure of 20 - 125 psi (0.138 - 0.862 mPa) is required.
WARNING
Make sure to connect the water line only to a potable water source.
CAUTION
• Do not reuse an old hose set. Use the new hose sets supplied with your refrigerator
only.
• The water line installation is not covered by the Warranty of this product. Read carefully
through these instructions to protect your property and prevent possible damage.
• Banging pipes (water banging in the pipes) can cause damage to the refrigerator, and
lead to water leakage or ooding. If you encounter this problem, contact a plumber for
professional assistance.
• To prevent burns and product damage, do not connect the water line to a hot water
source.
• Do not install the water line in areas where temperatures fall below the freezing point.
• When using any electrical device (such as a motorized drill) during installation, be sure
the device is insulated and properly grounded to prevent electric shock.
• All installations must be in accordance with local plumbing code requirements.
• The water lter must be replaced as instructed by the manufacturer or the retailer.
• To purchase additional water lters, contact the manufacturer or the retailer of the lter.
NOTE
• You can purchase the water line installation kit from your retailer. We recommend using
a kit that contains copper tubing and a 6 mm (1/4”) compression nut.
• In an area with low water pressure (below 20 psi (0.138 mPa)), you can install a booster
pump to compensate for the low pressure.
Installation
Untitled-1 4 2021-09-06 10:46:59
English 5
Installation
Install the Auto Ice Maker
To purchase a new Auto Ice Maker (part type : RA-TIMO63PP/AA), visit the Samsung
website (www.samsung.com) or contact your retailer.
Ice maker kit
Ice maker Ice bucket
Water line (Blue) Water line (White) Flexible tubes Fixers
Tools required (not provided)
Phillips screwdriver
Untitled-1 5 2021-09-06 10:47:00
Installation
English6
Installation
To install the ice maker kit
WARNING
Refrigerator must be disconnected from the source of electrical supply before attempting
the installation.
A
A
1. Remove the screws tightening the water
inlet cover (A) located on the top of the
refrigerator. Then, slide out the water
inlet cover (A) to remove.
- After removing the water inlet cover
(A), remove the aluminum seal.
A
2. Remove the pipe plug foam (A) from the
pipe.
A
B
3. Slide the exible tube (A) towards the
water inlet tube (B) (with a white water
line) and secure it to the water inlet tube
(B).
NOTE
Do not remove the cap plugged in at the
end of the white water line.
Untitled-1 6 2021-09-06 10:47:00
English 7
Installation
A
4. Straighten the wire (A) attached to the
white water line and put it into the
water inlet on the top of the refrigerator.
Be careful not to damage the wire.
A
B
5. Insert the water inlet tube (A) (with a
white water line) into the water inlet on
the top of the refrigerator. Secure the
water inlet tube (A) with the hook (B).
Untitled-1 7 2021-09-06 10:47:00
Installation
English8
Installation
B
A
B
6. Place the aluminum seal (A) on the
water inlet tube. Then, slide the water
inlet cover (B) back into its place, and
then fasten the water inlet cover (B)
with the screws.
NOTE
Make sure the exible tube is securely
xed to protect the bending part of the
water line.
A
7. Open the freezer door, and then remove
the shelf (A).
Untitled-1 8 2021-09-06 10:47:00
English 9
Installation
A
A
8. Remove the screws fastening the cover
(A) on the inner upper corner of the
freezer. Then, remove the cover (A) by
pulling it to the front.
A
9. Connect the wire harness (A) of the
white water line (which you have
inserted through the water inlet on
the top of the refrigerator) to the right
socket in the freezer. Make sure the
connector is fully inserted. (You should
hear a clicking sound.)
A
10.Connect the wire harness (A) of the ice
maker to the left socket in the freezer.
Make sure the connector is fully inserted
to prevent system failure.
Untitled-1 9 2021-09-06 10:47:01
Installation
English10
Installation
A
B
B
11.Insert the ice maker into the front side
of the grommets (A) as shown. Then,
push the ice maker (B) inwards to the
end. To prevent deviation of the ice
maker, make sure the ice maker ts into
position.
A
12.Tighten the provided screws (x2) to
attach the ice maker (A) rmly to the
refrigerator.
- Make sure the screw holes are
aligned with each other before
tightening the screws.
A
13.Put the ice bucket (A) on the shelf as
shown. By design, the ice bucket (A) is
supposed to sit behind the ice maker.
Otherwise, the ice cubes from the ice
maker will not collect in the bucket as
intended.
A
14.Unscrew the screws to remove the
compressor compartment cover (A) at
the back of the refrigerator.
WARNING
Be careful not to get a cut on your
hands when removing the compressor
compartment cover (A).
Untitled-1 10 2021-09-06 10:47:01
Table of contents
Languages:
Other Samsung Ice Maker manuals
