Sandstrom SKET510 User manual

Instruction Manual
Brushed Aluminium Kettle
SKET510
GB-4 GB-5
Visit Partmaster.co.uk today for the
easiest way to buy electrical spares and
accessories. With over 1 million spares
and accessories available we can deliver
direct to your door the very next day. Visit www.partmaster.co.uk or call
0870 6001 338 (UK customers only) Calls charged at National Rate.
This symbol on the product or in the instructions means that
your electrical and electronic equipment should be disposed
at the end of its life separately from your household waste.
There are separate collection systems for recycling in the EU.
For more information, please contact the local authority or
your retailer where you purchased the product.
SPECIFICATIONS
Mains supply : 230V-240V ~ 50Hz
Power consumption : 2200-2400W
We continually strive to improve our products, specifications may change
without prior notice.
SAFETY FIRST!
For your continued safety and to reduce the risk of injury or electric
shock, please follow all the safety precautions listed below.
• Read all the instructions carefully before using this appliance and keep
them for future reference.
• Retain the manual. If you pass the appliance on to a third party, make
sure to include this manual.
• Unplug the appliance from the mains socket when not in use, or before
cleaning any part of the appliance.
• Allow the appliance to completely cool down before cleaning.
• Never immerse the appliance in water and always keep the electrical
contacts dry.
• Never place the appliance on or near a source of heat such as a
cooker ring or gas flame.
• Always place the appliance on a dry, flat and stable surface.
• Avoid contact with the steam from the appliance’s spout. Take care
when pouring or refilling after boiling.
• To prevent the appliance from boiling dry, do not fill with water less
than the minimum level indicated.
• Do not use the appliance to heat anything other than water.
• Do not interfere with the normal working of the switch.
• Always keep the appliance out of the reach of small children and never
allow the mains cable to hang over the edge of the work surface.
Children should be taught about the dangers of boiling water.
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instructions concerning the use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• If the mains cable is damaged it must be replaced by the
manufacturer, its service agent, or similarly qualified persons in order
to avoid a hazard.
• Do not let the mains cable overhang the edge of the work surface or
allow it to touch hot surfaces or sources of heat or flame.
DGS Retail Ltd • Maylands Avenue • Hemel Hempstead •
Herts • HP2 7TG • England
Congratulations on the purchase of your new
Sandstrøm Kettle.
We recommend that you spend some time reading this instruction manual in order to
fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep this instruction manual
for future reference.

GB-1 GB-2 GB-3
UNPACKING
Remove all packaging from the kettle. Retain the packaging. If you
dispose of it please do so according to local regulations.
The following items are included:
• The kettle
• Instruction Manual (P.N.: SKET510-001)
If items are missing, or damaged please contact Partmaster (UK only).
Tel: [phone] for assistance.
FIRST TIME USE
Clean your kettle by boiling a full kettle of water twice and then
discarding the water.
KEEPING THE MAINS CABLE TIDY
Extend the mains cable in the kettle stand to the required length. Locate
the mains cable in one of the slots in the stand. For safety it is
recommended that the length of the exposed mains cable is kept as
short as possible. Place the kettle stand on a firm level surface and plug
in the mains plug to the mains socket.
PRODUCT OVERVIEW
FILLING THE KETTLE
Press the open button to open the lid and fill the kettle with the required
amount of water.
Do not exceed the maximum fill level
(Max 1.7L) as indicated inside the kettle
and not less than the minimum fill
level (Min 0.5L).
CLEANING THE KETTLE
The kettle exterior should be cleaned with a soft damp cloth. Do not use
abrasive cleaners or scouring pads which may damage the finish of the
kettle.
Never immerse the kettle or kettle stand in water and always keep the
electrical contacts dry. Disconnect from the mains before cleaning the
kettle stand.
If the kettle is overfilled, boiling
water may be ejected from the
spout and cause scalding.
This kettle must only be used with the stand provided.
SWITCHING ON
Place the kettle on the stand and press the power switch to the ON
position (indicated by the symbol ‘I’).
The indicator on the side of the kettle will illuminate to indicate that the
kettle is operating.
If there is insufficient water in the kettle, the automatic safety
cut-out will operate. If this happens, allow the kettle to cool for ten
minutes before refilling with cold water and re-boiling.
Do not insert any foreign objects or allow any liquid to spill into the
Power Connector Hole.
DESCALING THE KETTLE
Depending on the hardness of the water
in your area, limescale may be
deposited on the heating element and
the inside of the kettle. This normal
build-up is not harmful to health but an
excessive amount of scale may affect
the performance of the kettle.
To descale, fill the kettle with distilled
water up to three-quarters of the Max
level and bring the water to boil. After
the kettle has switched off, add a
descaling solution following the
manufacturers instructions. Never
attempt to descale the kettle by
chipping or scraping with a sharp
implement.
CLEANING THE REMOVABLE SCALE FILTER
To prevent loose particles of limescale being poured into your beverage,
your kettle is fitted with a filter. You may remove the filter to clean it.
To remove the filter, open the lid, lift up the filter from the bracket at the
spout.
To refit in the filter, open the lid, place the filter inside the bracket at the
spout, and push it down till it fit in place.
Never open the lid while the water is
boiling. The steam coming out from the
kettle is very hot.
Ensure that the switch is not obstructed
and the lid is firmly closed. The kettle will
not turn off if the switch is obstructed or if
the lid is open.
WHEN THE WATER HAS BOILED
The kettle will automatically switch off (indicated by the symbol ‘0’ ).
After removing the kettle, there may be some water on the surface
of the stand. This is condensation from the steam that causes the
kettle to automatically switch off after boiling. This is normal and
should not be a cause for alarm.
Power Connector Hole
Spout
Water Fill
Level
Kettle
Stand
Open Button
Handle
Power Switch
Lid
slot
slot