Sandusky Shooting Stand Table User manual

Shooting Stand Table Assembly
Assembling your shooting stand is very easy. You will need a
Phillips Screwdriver and a 4mm Allen wrench to complete the
assembly. Each table will require twelve (12) connector bolts,
and eight (8) screws, all included.
Step 1: Using three (3) connector bolts and the 4mm allen wrench, attach the left panel (Part A)
and back panel (Part B) as indicated in the picture below. Do not fully tighten
.
Step 2: Using two (2) connector bolts, attach the front panel (Part C) to the left panel (Part A).

Step 3: Using four (4) phillips screws, attach the bottom shelf (Part D), to the cross supports on
parts B and C. Note, the countersunk holes on the shelf should be facing up.
Step 4: Using five (5) connector bolts, attach the right side panel (Part E) as indicated in the
image below. Ensure Parts B, C, and D fit in the grooves on Part E. Do not fully tighten the
bolts.

Step 5: Using two (2) connector bolts, attach the top front panel (Part F) to the left and right
side panels (Parts A and B).
Step 6: Using four (4) screws, attach the top shelf (Part G) to the cross supports on the back
(Part B) and top front panel (Part F).
Step 7: Tighten all connector bolts and screws.