Sangean DT-200V User manual

1 . On/Off Button
2 . Volume Control
3 . Earphone Jack
4 . Lcd Ddisplay
5 . Tuning Control
6 . Tuning Control
7. Band Selection Button
8. Mono/Stereo Button
9. Memory Button
10. Select Button
11. Speaker On/Off Switch
12. Battery Compartment
13. Lock Switch
14. Belt Clip
LOCATION OF CONTROLS
Congratulations and welcome to
The SANGEAN WORLD OF LISTENING!
To insure proper operation please famililarize
Yourself with these instructions before using your
New receiver
2

3
2
3 1
5
6
7
8
13
4
11
9
10

4
14
12

The battery cover is located on the back of the unit.
Slide the cover in the direction of the arrow to gain
access to the battery compartment(12). Insert 2
AA batteries into the compartment(12). Make sure
that the batteries are positioned in accordance with
the diagram located below batteries in battery com-
partment. Replace cover.
BATTERY INSTALLATION
NOTE:
(1) A flashing "E" appearing on the LCD
Display indicates a weak battery and
replacement is necessary
(2) To ensure that the preset memories are
not lost during the battery replacement,
two steps must be followed . Make sure
that the power ON/OFF switch is in the
"OFF" position and the battery
replacement is completed within one
minute . If these two steps are not
accomplished , the memory will have to
be reset
5

Adjust the Volume Control(2) by rotating clockwise
to increase Volume.
ANTENNA/EARPHONE USE
The cord connecting the headphones to the re-
ceiver acts as an antenna during FM/TV reception
and should be extended as much as possible to
increase FM/TV sensitivity . Insert the Earphones
into the Earphone Jack(3).Abuilt-in Ferrite Ante-
nna is provided for AM reception and it is only
necessary to rotate the radio for maximum signal
strength during AM listening
SPEAKER ON/OFFSELECTOR
speaker Output may be turned on or off using
the Speaker ON/OFF Selector (11).A( ) will
appear in the LCD Display (4) if the Speaker
On/Off switch(11) is in the off position and the
headphones are inserted into the Earphone
Jack(3).The Speaker On/Off Selector must
be in the Off position with the earphones
plugged into the earphone jack to receive FM
stereo programs
VOLUME CONTROL
6

AM 520-1710KHZ Internal/Rotate radio for
best reception
FM 87.5-108MHZ External/Make sure Head-
phones are inserted into
Headphone Jack
TV ch.2-13(VHF) External/Make sure Head-
phones are inserted into
Headphone Jack
TUNING THE RADIO
BAND FREQUENCY ANTENNA
ASCAN TUNNING
Turn on the Radion by pressing On/Off Button
(1).Select AM,FM or TV Band by pressing
Band Selection Button(7) and then press and
Hold the Tuning Control(5) or(6) for more than
1/2 second. The Radio will Scan all the
frequencies in that Band and will stop
automatically for 3-4 seconds each time it
lands on an active station.Push the Tuning
Control again and the Radio will stay at the
Station you have selected. The Radio will turn
tself off automatically after 60 minutes of
Operation or you may turn it of at anytime by
Pressing the On/Off Button.
7

BMANUAL TUNING
Turn on the Radio by pressing On/Off Button
(1). Select AM,FM or TV Band by pressing
Band Selection Button (7).Desired station
May be selected by either pressing the Tuning
Control(5)or(6) intermittently until the desired
Station is reached or pressing and holding the
Tuning Control until the desired station is
Reached. Release and push the Tuning
Control once again to retain the desired
Station.
CMEMORYTUNING(STAION PRESET)
Turn on the Ridio by pressing On/Off Button
(1).Select AM or FM Band by pressing Band
Selection Button (7).Tune to the desired sta-
Tion using the Manual or Scan Tuning Methods
As reached and indicated in the desired station
Is reached and indicated in the LCD Display
(4) Press the Memory Button (9).A M will
flash in the LCD Display. During its flashing
push the Select Button (10).The Number of
the Memory position will appear successively
each time the Select Button is pressed. Select
the Number Position for the station appearing
in the LCD Display by pressing the Menory
Button (9) when the correct position appears
8

In the LCD Display. You may store a total of
19 stations in any mix from any band.Original
stations are eliminated when new stations are
selected to take their places.
DMEMORY TUNING (STATION RECALL)
Turn on the Radio by pressing On/Off Button
(1). Select AM, FM or TV Band by pressing
Band Selection Button (7). Pressing and
Holding the Select Button (10) for more than
1/2 second will begin displaying the stored sta-
tion and their associated numbers one by one
in the LCD Display .Numbers order of display
may be changed form ascending to descen-
ding and vice versa at any time by pressing
the Tuning Controls (5) or (6) .It is only
necessary to press the Select Button a second
time when the desired station appears in the
LCD Display to retain the desired station
Monaural or Stereo reception may be selected
Through the Headphones during FM reception by
Alternately pressing the Mono/Stereo Button (8).
The Speaker On/Off Switch (11) must be in the Off
Position.
MONO/STEREO BUTTON
9

To prevent accidental changing of any o the radio
settings move the Lock Switch (13)to its up , locked
position( ). To release simply move the switch
to its down position. IT IS IMPORTANT TO MAKE
SURE LOCK SWITCH IS IN ITS DOWN POSITION
WHEN RADIO IS TO BE USED AS RADIO IS
COMPLETELY INOPERATIVE UNTIL LOCK
SWITCH IS RELEASED . If the Radio is not to be
Used for any extended period of time battery power
Savings may be realized by setting-Lock Switch
In its locked ( ) position during storage.
LOCK SWITCH
A removable Belt Clip(14) is provided on the back
Of the unit.It can be removed by gently pushing
Where indicated on the back of the clip and moving
The clip in the direction of the battery case ad in-
Dicated in the illustration.Reverse procedure to
Reinstall clip.
BELT CLIP
10
REMOVAL REINSTALL
14 14