Sangean DT-210 User manual

DT-210/DT-210L/DT-210V
GB
Revision 1

1

2
Controls
Stereo/Mono/Speakerswitch
Memorybutton
Tuning Up/Down
EarphonesJack
VolumeControl
Powerswitch
Display
MemoryRecall
DBB (Deep Bass Boost)selection
Band selector
BeltClipholder
Lock switch
Batterycompartment
BeltClip
Display
Waveband indicator
DBB on
Keylock indicator
Lowbatteryindicator
Frequency display
Memorypreset
Stereo indicator
90 minutesautoshutoff indicator
1
2
3
5
7
9
11
13
14
4
6
8
10
12
A
H
E
F
B
D
C
G
GB

3
Installing batteries
1.Position the radiofacedown.
2.Press the catchand slide inthe direction
ofthe mark.
3.Lift up the batterycoverand insert
1xUM-4(AAA)sizeon eachside of
batterycompartment. Makesurethe
batteriesarepositioned inaccordance
withthe diagramindicated.
4.Replacethe batterycover.
Batteryreplacement
The batteryindicatorwill appearand
flashinthe displaywhen the batteriesarein
need ofreplacement.Afterremoving the
batteries,you haveapproximately3minutes
toreplacethe batteriesafterwhichthe preset
memoryinformation will be lost.
Operating theradio

Addendum
Important:
Please always replace the batteries within
3 minutes and always with fresh batteries.
If the radio malfunctions after battery
replacement,
1. Switch off the radio and remove the
batteries.
2. With the aid of a suitable implement (the
end of a paper clip or pen), press the
RESET button located in the battery
compartment for about 5 seconds, this
will reset the microprocessor and clear
all stations stored in the preset memory.
3-1

GB
4
Searchtuning
1.Switchon the radiobypressing the Power
button.
Note:
The radioisoriginallysettobe 90 minutes
autoshutoff afterPowerisswitched on
(symbolwill appearon the display).
If you don’tneed thisfeature,press Power
button formorethan 2secondsuntil symbol
removed fromthe display.
2.Selectthe required waveband by
repeatedlypressing the Band button.
OnFMand TVband (DT-210Vonly),
connectthe supplied earphonesasthe
antenna orthe wireantenna.OnAM(MW)
and LWband (DT-210L),rotatethe radio
forbestreception.
3.Press and holddowneitherthe Tuning Up
orDownbuttonsuntil frequency inthe
displaybeginstochange rapidly.
Releasethe button.
4.The radiowill scan the selected waveband,
stopping eachtimeiffindsastation of
sufficientstrength.Adjustthe volume
controltothe required level.

5
Manualtuning
1.Switchon the radiobypressing the Power
button.
2.Selectthe required waveband and connect
the supplied earphonesorwireantenna for
FMand TVband (DT-210V)listening.
OnAM(MW)orLWband (DT-210L),
rotatethe radioforbestreception.
3.Asinglepress on eitherthe Tuning Up/
Downwill change the frequency up or
down.Adjustthe volumecontroltothe
required level.
Presetting stations
You maystoreup to15 stationson FMband
and 10 stationsonAM(MW)band forDT-210
(10 stationseachonAM/FM/TVband for
DT-210Vand 10 stationseachonAM(MW)/
FM/LWband forDT-210L).
1.Tune intothe required stationsusing one
ofthe tuning methodspreviously
described.
2.Tostorethe station,press MEMObutton,
displaywill flashMand the suggested
memorylocation.Press MEMObutton
againtofinalizethe station presetting.
During the Mand suggested memory
location areflashing,you mayuseeither
Tuning UporDowntochange the memory
location toedityourmemoryprogramthen
press MEMObutton againtofinalizethe
presetting.

6
GB
Recalling apresetstation
1.Switchon the radio.
2.Press RECALL button and Tuning Up/
Downtorecall required presetstation
Displaywill flashpresetstation.
3.Press RECALL button again,oncethe
required presetstation isfound.
Lock Switch
The lock switchlocated on the rearcabinet
isused topreventunintentionaloperation.
1.Slide the lock switchtothe up locked
position ,the symbolwill appearin
the display.The powerand all other
buttonswill be disabled.Thiswill prevent
accidentaloperation when the radiois
packed inasuitcase.Toreleasethe lock
switch,movethe switchtothe down
unlocked position,the symbolwill
be removed fromthe display.

7
Earphones and antenna
The earphonesalsoactsasthe FMantenna
when plugged intothe earphonesjack.While
listening viaspeaker,you mayplug the sup-
plied wireantenna intothe earphonesjack,
and setthe ST/MO/SP switchtothe SP
(speaker) position.
ST/MO/SP(Stereo/Mono/Speaker)
1.Switchthe switchtoSP (speaker) position,
whileyou listen tothe radioprogramvia
speaker.Makesuretoplug the supplied
wireantenna orthe earphonestogetbest
FMreception.
2.Thisradioiscapableofreceiving FM
stereo radioprogrambyplug the supplied
earphonesintothe earphonesjack and set
the ST/MO/SP switchtoST(stereo)
position,displaywill showstereo symbol.
If the station being received isweak,
somehiss maybe audible,toreducethe
hiss,switchthe ST/MO/SP toMO(mono)
position.The stereo indicatorwill be
removed fromthe display.

GB
8
ChangeAM(MW)band tuning step
(availableonlyon DT-210/Vnotfor
LWversion )
InEurope and otherpartsofthe world,AM
(MW)tuning step are9kHz,inAmericathe
AMtuning step is10 kHz.
Tochange theAMtuning step from10 kHzto
9kHz,proceed asfollows,
1.Press TuningDownbutton then the power
button toswitchon the radio,the radio
will be changed into9kHztuning step on
AMband.
Tochange theAMtuning step from9kHzto
10 kHz,proceed asfollows,
1.Press Tuning UPbutton then Power
button toswitchon the radio,the radiowill
be changed into10 kHztuning step on AM
band.