Sanipex AQUAECO AQP-WBT-220-CP User manual

AQP-WBT-220-CP
AQUAECO BATH FILLER MIXER WITH PUSH TYPE WASTE
www.sanipexgroup.com
AQUAECO
WASHROOM AND PLUMBING SOLUTIONS

IMPORTANT PLEASE READ

 

 






 L  C 



 x 
          
          
 



   








 









Cleaning All surface should be cleaned using a clean damp cloth. No abrasive cleaning agents or
materials should be used.
7. Screw two adapter connectors 2 in 1 tap body ,and
connect to inlet tube 11 (as Figure III, Pay attention to the
direction of the cold and heat water inlet),
8. Turn on water supply value and handle to chock all the
joints to make sure there is no leakage and the product
can work normally.
V. Using instruction(Figure IV).
1.Adjust the flow rate and the water temperature: move
the handle by hand.
Installation & operation instruction
Installation Notice.
1. Flush pipes to get rid of any debris blocked in pipes
before installation.
2. After installation, check all the joints to make sure they
are firmly connected. Then turn water on and o
repeatedly to ensure there are no leaks around the joints
then the product can be used normally at this stage.
Operation Notice.
1. The product is used between water pressure 0.5 to 4bar,
water temperature 0-90'C.
2. The waste and the tap is suitable for being installed in
the bathtub which thickness is 5-10 mm(as Figure I).
3. Regularly clean the tap with soft damp cloth.
4. Read all the instructions completely before proceeding.
III. Installing steps (Figure II).
1. Screw out the both sides of adapter connector 2.
2. Screw out the lock nut 5, pull 4 , 3 out in order.
3. 1Tap body should be plugged in bathtub overflow hole A
(Pay attention to use S2.5 wrench adjustment M4 screw
length).
4. Put 3. 4 into 1 tap in order, then screw in 5 closely by
wrench (Pay attention
to adjust the direction and the location of the overflow of 1
Tap),
5. Clic-Clac Bath Waste 7 be installed to bathtub.
6. Put 10. 9. 8 into 6 plastic pipes in order, and put it into 7
at the port of C. At last, use the part 10 plastic nut to lock
part 7 bath waste.

INP-WBT-220-CP-03-23
www.sanipexgroup.com
AQUAECO
WASHROOM AND PLUMBING SOLUTIONS